These are the best quality CTS pots available right now.

Description

SHORT SPLIT shaft SPECS

1/4" split shaft for fine-knurled (24-spline) US Spec knobs.

250K's Typically used on Strats

500K's Typically used on SG's, Flat Top Non Carved Top Les Pauls, PRS's, LP Jr's, Jazzmasters and many other models of guitars, but can be used on any Guitar that requires a 500K Split shaft Potentiometer.

Specifications

shaft Style: (24 Spline) Split shaft , Fine Knurling

shaft Diameter: 0.234” (5.94MM)

Thread: 3/8” X 32

Thread Height: 3/8” (9.52MM)

Required Mounting Hole: 3/8” (9.52MM)

POT VALUES:

We Spec these pots to be over the stated value rather than under. With tolerances you can get a -/+ swing of quite a bit, so we've chosen to aim for a Little over, so that the actual end value is closer to our target Range .

- 250K pots are spec'd to 275K, so they'll likely read from 240K to 280K Ohms

- 500K pots are spec'd to 550K, so they'll likely read from 490K to 570K Ohms

- 1Meg Pots are spec'd to 1Meg, so they'll likely read from 900K to 1025K ohms

Installation Tips for Knobs on Split shaft Pots

CTS split shaft pots are made to fit USA Spec 24 spline push-on knobs. Import Guitars will need new USA Spec Knobs. We recommend that you slightly crimp together the top of the potentiometers shaft ever so slightly so that when you go to PUSHshaft by exerting too much downward pressure.

**These are just estimates on values, if you need a guaranteed reading on a pot please email us first and we will provide you with a quote on hand metered pots**

Each CTS pot includes a flat washer, lock washer, and 1 hex mounting nuts for Custom height adjustment on a pickguard, control plate, or directly on to the guitars top from inside the control cavity.

**PLEASE NOTE - THESE ARE NOT EMERSON BRANDED POTS**

500K's Typically used on SG's, Flat Top Non Carved Top Les Pauls, PRS's, LP Jr's, Jazzmasters and many other models of guitars, but can be used on any Guitar that requires a 500K Split shaft Potentiometer. We Spec these pots to be over the stated value rather than under. With tolerances you can get a -/+ swing of quite a bit, so we've chosen to aim for a Little over, so that the actual end value is closer to our target Range . CTS split shaft pots are made to fit USA Spec 24 spline push-on knobs. Import Guitars will need new USA Spec Knobs. We recommend that you slightly crimp together the top of the potentiometers shaft ever so slightly so that when you go to PUSHshaft by exerting too much downward pressure. Each CTS pot includes a flat washer, lock washer, and 1 hex mounting nuts for Cus