Custom printed circuit board designed for the high powered crossover of the Soundstage 15 2-way DIY speaker design by Toids DIY Audio.

Take the guesswork out of crossover assembly, these boards make the assembly process quick and straightforward.

These boards measure 6.0" W x 6.75" H and feature large solder pads and wide copper traces for great electrical connectivity.

I was commissioned to build a small run of these crossovers and am listing the left over PCBs from that batch.

Photos of assembled crossover for reference only!

Includes:

1x Crossover PCB for the Soundstage 15 speaker design.

3x Terminal blocks which accept up to 12 gauge wire.

4x Snap in PCB standoffs.

4x Mounting screws (screw finish may vary).

Requires:

High powered crossover components for the Soundstage 15 speaker design.

Assembly:

Glue components to the correct positions on the board (hot melt glue works great). Secure inductors with non metallic cable ties. Solder components leads to the pads on the bottom of the board. Attach wires from input and drivers and mount crossover board.

Note the resistors have to be soldered to hold them in place. I found it is easier to install and solder them one at a time from the top side of the board then finish soldering at the bottom.