CRYPTON RAC ACT 1 FAULT CODE READER SCAN TOOL


CHEAPER VERSION MAUFACTURED FOR THE RAC WITH NO ACTUATOR TESTING

(SWITCHING FUEL PUMP, INJECTOR ETC ON & OFF TO TEST FOR FAULTS)


WITH SCANNED PDF USER MANUALS ON CD

 


RAC-C2 FORD, ROVER MEMS SPI, FLASH CARD

 

MINI, METRO, MONTEGO

 

214, 220, 220 TURBO

 

414, 420, 420 TURBO

 

820, 820 TURBO


FORD FIESTA

1.1, 1.3, 1.4, CFi 89-96

1.6EFi 89-93      1.8 ZETEC 92-95


FORD ESCORT/ORION

1.6EiI 90-96,    1.6 ZETEC 92-96,    1.8 ZETEC 91-96

COSWORTH 92-96


FORD SIERRA

2.0i OHC 85-89,    2.0i DOHC 89-93,

COSWORTH 90-93

 2.8i V6 87-89,   2.9I V6 89-93

2.9I V6 CAT 89-93


FORD GRANADA

2.8i V6 85-89,  2.9i V6 86-93,  2.9I V6 CAT 86-94,  2.9 V6 24V 91-94



 

RAC-L2 DIAGNOSTIC LEAD FORD 3 PIN PLUGS,  ROVER MEMS SPI WHITE 3 PIN PLUG (UNDER BONNET)

 

 

FOR USE ON ALL SPI ROVERS INCLUDING

 

MINI COOPER 1.3i NOV 1991-ON

MINI CABRIO' CONV 1.3i JAN 1993-ON

 

 

TESTING FUNCTIONS

 

FAULT CODE READING

 

FAULT CODE ERASING

 

 LIVE DATA

 

ENGINE SPEED, MAP SENSOR, COOLANT TEMP,

AIR TEMP, BATTERY VOLTS, THROTTLE POT VOLTS, LAMBDA VOLTS

 


 

IMPORTANT

 

A fault code reader is a micro computer that talks to your cars ECU if there are wiring problems with the 3 pin diagnostic plug or problems with your cars ECU the fault code reader may not be able to communicate with your car.

IF THE FAULT CODE READER WILL NOT SWITCH ON OR YOU GET THE USER MESSAGE 'UNABLE TO ESTABLISH COMMUNICATION'


1.You use the F2 push button to turn the ACT on


2. The red crocodile clip goes to the 12volt positive terminal on the battery or starter motor solenoid (is there a good connection) not connected on the wire insulation or the starter motor connection


3. Is the 3 pin plug connected correctly, the white 3 pin diagnostic plug may have a black rubber cover to keep the terminals clean (you can also have bad connections) or have the terminals been pushed up into the plug or socket. It is not the green socket that is for the alarm


4 Is the flash card inserted correctly, the copper terminals side of the card should be inserted first towards the very bottom of the act not the keyboard side of the ACT.

Hope this helps you, I did connect the ACT up  to take the live data picures before the auction so I know it works.

 

FROM OVERSEAS I CAN ONLY ACCEPT PAYPAL

 

 

LOW START

 

NO RESERVE

 

HAPPY BIDDING