The Removal Tool Tip is used to engage and remove the Male from the Denture Cap.
The Seating Tool is used to seat the Locater Male.
The Anchor Driver with the Abutment Holder Sleeve carries the Abutment securely and places it onto the implant.
Very Easy to Use. Follow these steps to utilize the 3-in-1 Locater Core Tool:
Loosen the Removal End of the Core Tool. You will see a visible gap between the removal tool and seating tool.
Insert the Removal Tool Tip into the Denture Assembly and push straight into the Male. Tilt the tool so that the sharp edge of the tip will grip the Male and pull it out of the Denture Cap.
Once the Male is removed proceed to point the tool down and away from you. Tighten the Removal Tool Clockwise back onto the Core Tool. This will disengage the Male from the tip of the Removal Tool
Separate the Removal Tool part of the Locater Core Tool. Use the Seating Tool to place a new Male into the empty Denture Cap