|
|
|
|
|
|
|
|
|
|
|
Specifications:
1) Thickness: 1" / 25mm
2) Vehicle Bolt Pattern(PCD): 5x100mm
3) Wheel Bolt Pattern(PCD): 5x4.5" / 5x114.3mm
4) Hub Diameter: 56.1mm / 2.21"
5) Thread Size: 12x1.25 / M12x1.25 / 12mmX1.25
Note:Please make sure you take the proper neasurements gefore purchasing
Package include: 2Pcs Wheel Spacers Adapters
What should I pay attention to during installation?
1) Check to make sure that the wheel spacer fits perfectly with the hub/axle stub and the inner mounting surface of the wheel.
2) Make sure that the wheel bolts being used are of the appropriate length, not too long or too short.
3) DO NOT proceed if both of the wheel spacer do not fit.
4) Please be sure to clean the rust on the hub before starting the installation, otherwise it will affect the working life of the spacers.
5) Make sure that you get 5-7 FULL TURNS of the lugs when installing. Torque them down to the manufacturers specs (up to and not greater than 110ft lbs).
6) Avoid using an impact wrench because improper usage may cause the lug nuts/bolts to break or loosen while driving causing a potential injury or accident.
7) All lug nuts, bolts and torque must be checked after driving the first 50 miles after installation. Afterwards, please check all lug nuts and bolts every 3,000-5,000 miles.
8) Alignment is necessary after installation, this will prevent any wobble and vibration from occurring.
How to measure the fender gap to choose suitable thickness?
1) Line up a straight edge ruler against the sidewall of the tire, use the measuring device to measure from the inside of the ruler to the inner fender lip.
2) Please take multiple measurements and use the smallest data point.(The most closest spot may be at the front or rear edge of the fender). The maximum recommended spacer
thickness= the smallest gap - 3/8"(10mm)
About the wheel bolts:
Your Factory wheel studs may extend past the surface of the wheel spacers. In this case you will need to:
1) Shorten the factory studs.
2) The wheels need to have the open slots (cavities) between mounting holes.
3) Purchase a set of shorter studs and replace them with the factory studs.
Vehicle Fitment Information:
Saab:
Saab 9-2X 2005-2006
Scion:
Scion FR-S 2012-2016
Subaru:
Subaru BRZ 2012-2023
Subaru Baja 2003-2006
Subaru Crosstrek 2016-2023
Subaru Forester 1998-2018 (2019 2020 SJ Only)
Subaru Impreza 1993-2013
Subaru Impreza 2014-2023 (WILL NOT FIT WRX)
Subaru Legacy 1990-2014
Subaru Outback 2000-2013 (2014 BR Only)
Subaru XV Crosstrek 2013-2015
Toyota:
Toyota 86 2017-2020
Toyota GR86 2022-2023
Before&After
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
1.We only accept PayPal.
2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages.
3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
4.Payment must be received within 10 days as auction ended or order might be delayed.
1. Orders processed within 24 hours of payment verification.
2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address.
3. The images shown are not the actual item and are for your reference only.
4. Fast shipping:All our packages use USPS First Class/UPS/Fedex.... Package Service
5. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS!
2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.
4. Return shipping is to be paid by the Buyer.
We maintain high standards of excellence (five stars review)and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Shop Category |
2x 1 Inch 5x100 to 5x4.5 Wheel Adapters Hubcentric Fits Subaru Impreza Forester
Specifications:
1) Thickness: 1" / 25mm 2) Vehicle Bolt Pattern(PCD): 5x100mm 3) Wheel Bolt Pattern(PCD): 5x4.5" / 5x114.3mm 4) Hub Diameter: 56.1mm / 2.21" 5) Thread Size: 12x1.25 / M12x1.25 / 12mmX1.25 Note:Please make sure you take the proper neasurements gefore purchasing
Package include: 2Pcs Wheel Spacers Adapters
What should I pay attention to during installation?
1) Check to make sure that the wheel spacer fits perfectly with the hub/axle stub and the inner mounting surface of the wheel. 2) Make sure that the wheel bolts being used are of the appropriate length, not too long or too short. 3) DO NOT proceed if both of the wheel spacer do not fit. 4) Please be sure to clean the rust on the hub before starting the installation, otherwise it will affect the working life of the spacers. 5) Make sure that you get 5-7 FULL TURNS of the lugs when installing. Torque them down to the manufacturers specs (up to and not greater than 110ft lbs). 6) Avoid using an impact wrench because improper usage may cause the lug nuts/bolts to break or loosen while driving causing a potential injury or accident. 8) Alignment is necessary after installation, this will prevent any wobble and vibration from occurring.
How to measure the fender gap to choose suitable thickness?
1) Line up a straight edge ruler against the sidewall of the tire, use the measuring device to measure from the inside of the ruler to the inner fender lip.
About the wheel bolts:
Your Factory wheel studs may extend past the surface of the wheel spacers. In this case you will need to:
Vehicle Fitment Information:
Saab:
Scion:
Subaru:
Toyota:
Before&After
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. 1.We only accept PayPal. 2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages. 3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.) 4.Payment must be received within 10 days as auction ended or order might be delayed.
1.We only accept PayPal.
2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages.
3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
4.Payment must be received within 10 days as auction ended or order might be delayed.1.We only accept PayPal.
2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages.
3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
4.Payment must be received within 10 days as auction ended or order might be delayed.
1. Orders processed within 24 hours of payment verification. 2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address. 3. The images shown are not the actual item and are for your reference only. 4. Fast shipping:All our packages use USPS First Class/UPS/Fedex.... Package Service 5. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS! 2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable. 3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement. 4. Return shipping is to be paid by the Buyer.
We maintain high standards of excellence (five stars review)and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Copyright of Top-liftsupport. All rights reserved. |