Composition structure:
1. Gun body: gun trigger, air flow control valve, housing, spring hook;
2. Nozzle: nozzle, sealing ring; (1 FN5 nozzle)
3. Cup: plastic cup, metal cup cover.
Note: Assemble and check all joints to ensure that all joints are tight.
Operation method: (air compressor is not less than 5KG)
1. Preparation:
According to the viscosity of the gel coat, choose the nozzle with the right diameter (the selected nozzle model number 1-5 (small to large); generally choose 4MM or 5MM. In the nozzle and jet, the gun and the gun body and the lid and the material Apply grease to the joints such as the cup.
When you are ready, follow the steps below.
2. Operation steps:
1 Cover the cup on the cup filled with the material and press the lid.
2 Force the nozzle into the air vent in front of the gun until the nozzle shows the air vent.
3 Hold the handle and hold the gun. The air is ejected from the air jet.
Precautions:
Note 1: When performing the above steps, the nozzle should always face upward to prevent the nozzle from leaking, tilt the gun body, spray the material, and adjust the control valve.
By atomizing the raw material to a better state, the nozzle is aligned with the surface of the mold to perform jet production.
Recommendation: When injecting, the tip is at a 90 degree angle to the surface of the mold.
Note 2: During the spraying process, please do not point the nozzle at yourself and others to avoid accidental injury. When stopping the injection, raise the gun head and release the gun at the same time to prevent the raw material from flowing out. Use the cleaning liquid to clean the gun body, the gun head and the material cup. Wash and apply oil for future use.
Technical indicators
* Air source pressure: 0.3~0.6Mpa;
* Cup volume: 1L
* Measuring Cup: 500ml
*Spray Nozzle: (4mm) FN5 5/32"
Nozzle outer diameter: 5.0
Nozzle inner diameter: 3.0
The package includes:
1* Spray Gun
1* Spray Nozzle (4mm) FN5 5/32"
2 * Plastic Cup (1000ml )
1 * Measuring Cup (500ml )