If your Jaguar is starting to look a little crusty at the front end of the sills, this panel will be what your MoT man will be looking for.

This is NOT a simple slap over the top get-it-through-the-next -MoT part.

Its an 800 mm long remanufacture of the front end of the sill skin, so has the styling features of the original panels - 

If you look closely at the lower part of the sill on your car, you will see its not just a simple curve top to bottom, one surface of the sill between feature lines starts at 30mm and grows to 40 mm wide. 

This panel also has the tapering front edge to match with the line of the front wing, and has the pressed lower edge 'drains' incorporated too.

Our Front Sill and Rear sill repair panels are common to both Short and Long wheelbase cars, our centre section is unhanded, and is long enough to do LWB, so will need to be trimmed back for SWB cars.

All our Jaguar Sills Skin pieces are made from 1mm gauge zintec steel. Zintec gives a good first step in corrosion protection, but is designed to weld through.

Any questions, just ask.