Kit Includes
- Ten Meters of Steel Wire (Diameter: 4 mm) with Pre-Assembled Wire Fixing L-shaped Plate | CAIS Telescopic Sliding Gate Hardware (QTY: 1)
- Wire Tensioner | CAIS Telescopic Sliding Gate Hardware (QTY: 1)
- Ground Fixing Screw and Nut (diameter: 12x200 mm)| CAIS Telescopic Sliding Gate Hardware (QTY: 2)
- Wire Fixing Plate (80x50x55mm Bracket) | CAIS Telescopic Sliding Gate Hardware (QTY: 1)
- Wire Tensioning Rollers (diameter: 60 mm) | CAIS Telescopic Sliding Gate Hardware (QTY: 2)
- Cover for Wire Tensioning Rollers (Diameter: 80x80x35 mm) with Bolts and Nuts| CAIS Telescopic Sliding Gate Hardware (QTY: 4)
Product Information
Telescopic Sliding Gate Hardware Set for 8-Meter Driveway Gate
[ Hot Dip Galvanized German Steel Made in Europe by CAIS ]
Telescopic Sliding Gate Hardware Kit for up to 8m opening Two-Part Driveway Sliding Gate (CAIS Telescopic 800 EU)
What are telescopic sliding gates?
The telescopic sliding gate is the “space-saving gate” since, compared to a conventional sliding gate with a single leaf, it comprises sliding gate leaves that overlap each other when opening, thus occupying less space.
Heavy Duty Telescopic Sliding Gate Opener Hardware German Steel with Hot Dip Galvanized. Made in Europe by CAIS.
Telescopic Sliding Gate Hardware Kit for up to 8m Opening Two-Part Driveway Sliding Gates
CAIS Telescopic Sliding Gate Hardware for Two-Part Driveway Sliding Gate
Includes:
Telescopic Sliding Gate Hardware for up to 8m Double Sliding Gate Telescopic System
- Ten Meters of Wire (Diameter: 4 mm) | CAIS Sliding Gate Telescopic System
- Wire Tensioner | CAIS Sliding Gate Telescopic System
- Ground Fixing Screws + 2 Nuts (Diameter: 12x200 mm) | CAIS Sliding Gate Telescopic System
- Wire Fixing L-Shaped Plate (80x50x55 mm) | CAIS Sliding Gate Telescopic System
- 2x Wire Tensioning Rollers (Diameter: 60 mm)| CAIS Sliding Gate Telescopic System
- 4x Cover for Wire Tensioning Rollers (Diameter: 80x80x35 mm)| CAIS Sliding Gate Telescopic System
Note: The gate frame and grid filling are not part of the set!
Telescopic Gate System Measuring Instructions
Measurements are necessary for creating a telescopic gate system.
The amount each gate travels to open with telescopic gates must be found first.
The "Telescopic Gate System" measurements are in the charts below.
How do telescopic sliding gates work?
The structure of the telescopic gate consists of two or more modular wings, and the way it works is similar to a telescope – when the wings are closed, they move one after the other. The telescopic gate, like the sliding gate, with the structure of the telescopic gates design slides on two rails side by side.
What is the difference between a telescopic gate and a sliding gate?
Traditional sliding gates need the same length of opening space, but telescopic gates allow twice the opening width into half the space. Example - If you had a four-metre opening but only two and a half metres of run-off area with a standard sliding gate, there is simply no way to install in this area. That can be triple or Quadro telescopic structure design gates according to requirements.
Two or three smaller sliding gates can be used to span a driveway that stacks one in front of the other; a little more than half or a third of the width of the driveway space is required to open. These are commonly known as 'Telescopic" or "Stacker" Gates.