This kit contains ONE PAIR (2) motor mounts and ONE (1) Motor Support.

Does your Seeburg jukebox sound warbly? Does the motor twist in the carriage when it hits the end of record rack? This is bad news! You’ll soon be paying hundreds of dollars to have a service tech come out to replace your motor and repair the torn wiring. Avoid all of this and replace the motor mounts as preventative maintenance!

Why pay for the entire mount and metal rings when you can buy JUST the rubber here from my store at a fraction of the cost you can find them from the large suppliers? For less than an hours’ worth of work total, you save yourself some hard earned cash (and in this economy, the more savings, the better).

Enhance your Seeburg Jukebox with this motor mount replacement rubber kit. Crafted for Seeburg brand, the kit is made of high-quality TPU (thermoplastic polyurethane) at shore hardness 95A, which guarantees a perfect combination of flexibility and durability. You can now enjoy your favorite tunes without worrying about the motor mounts’ condition.

These kits **DO NOT** include the metal mounting rings. With this kit, you are simply replacing *ONLY* the rubber motor mounts contained in and around the rings. This is extremely easy and should take an inexperienced person less than one hour to perform. Once your motor is loose from the coupler and out of the carriage block, remove the old mounts from the motor. If your motor mounts were deteriorated, then they should just pry right off from the center metal ring. You will then remove the old rubber mount from the existing rings and CLEAN the metal rings with a wire wheel or brush and DEGREASE the rings with alcohol, brake cleaner, mineral spirits, or something similar. Make sure to thoroughly clean and dry the metal mounting rings. You’ll then use a two part epoxy and dab a little bit on the contact surfaces of the old metal rings where it will meet the new rubber. Press in the new rubber and let cure. Once cured, reverse the process you did to take them out and reinstall the motor. It’s that simple! :)

For the motor support rubber, simply remove the old one (which are actually often completely absent due to rotting off) and press/ place in the new support rubber in the existing hole under the motor. Make sure to be careful and place the motor on top of the rubber support when reinstalling and not to knock it out of position. This is easy to do if you have large hands like me!

JOHNNY V’s NEW MOTOR COUPLERS ALSO IN STOCK! Please send me a message if your motor coupler is also hard. If so, this kit alone will not fix your warble problem. THE COUPLER MUST ALSO BE REPLACED! If you would like a new coupler, you must send in your old one for a core since these are rebuilt original pieces using 21st century technology.

If you have any questions please feel free to message me and I will be sure to respond promptly. Thank you for viewing and have a wonderful day!