Collecting listings has surprises
Description BASE is suitable for 3D printer manufacturers on batch production, and being used as main control board. It features an onboard AT. Its five motor outputs are powered by A4982 stepper drivers. Relative to the Ramps1.4, it adds heating output.
BASE is a feature rich electronics solution for Reprap and other CNC devices. The board can use the firmware as Ramps1.
. BASE is designed to be flexible in the user's power source availability, allowing any power supply from 12V-24V.4
Features
- Up to 5 motor driver with A4982
- compatible At and FT232 processors are compatible with all RAMPS class firmware
- fuse for short-circuit protection.
- Warm Tip: Dear buyer, Due to lighting effect,monitor's brightness,manual measurement and etc, there could be some slight differences in the color and size between the photo and the actual item. sincerely hope that you can understand! Thank you!
- Easy connect on AUX-1
- 3x temperature connectors for thermistors
- Firmware can use the configuration as ramps1.4
- 4x PWM capable power mosfet outputs with voltage for MainPower.(Bed,Extruder0,Extruder1, Fans)
- 4 layers PCB, optimize heat dissipation.
- Easy DISPLAY + SD-CARD connector,RepRapDiscount SmartController compatible pin header on board
- Color: As shown
- Material: Plastic and metal
- Size: 11x9x2cm