Get the kit of 5 parts to save on buying separately!
- 3D printed in the UK from recycled PETG with 70% infill as per Hope guidance.
- Colour Hope Lime Green so it doesn't get lost in your bike toolbox!
V4 - CALIPER ALIGNMENT TOOL
This tool is used to align the caliper with the disc.
Available for:
Sold Separately
- E4/RX4+ Caliper
- X2 Caliper
Instructions:
- Simply install the spacer instead of the pads and secure with the pad pin.
- Put over the disc and alternatively tighten the M6 caliper screws.
Note:
- Pistons needs all to be pushed into their bores.
- One side of the tool is for 1.8mm discs, the other side 2.3mm discs
On 4 pistons calipers; allows a single piston to come out at the time to facilitate cleaning and lubrification.
Available for:
V4 Caliper
Instructions:
- The brake must be fully bled.
- Remove the pads, present the step in front of the piston you want to come out.
- Install the tool instead of the pads and secure with the pad pin.
- Pump out on the master cylinder until the piston comes in contact with the tool.
Note:
Other pistons need to be pushed into their bores
Thin Pad Travel Spacer
- Prevents the pads coming into contact with each other accidentally when the wheel is removed.
- Ideal for travel where someone else may handle your bike and accidentally depress your brake lever when the wheels are off!
Available for:
Instructions:
- Simply clip the spacer onto the pad pin clip, pull down to remove
Note:
E4 and V4 use the same spacer
V4 Full Pad Spacer - Bleed Block
Prevents the calliper pistons coming out of the bore accidentally when the pads are removed.
Available for:
V4 Caliper
Instructions:
- Simply install the spacer instead of the pads and secure with the pad pin.
Note:
- All Pistons need to be pushed into their bores.
NOTE: Some text colours may differ depending on which filament I have in stock but it will always be a contrast colour so they are easily readable.