Use a hard, smooth stable surface, like a table, an ironing board is just too soft for a good image transfer.

As protection, use thick cardboard or pillow case as a base. We like the pillow case best.

We suggest you pre iron the garment and then lay it on the base, smooth it out, and then lay the printed ink jet transfer paper, with the picture facing downwards, onto the fabric exactly where you want it to be. Play with it a little bit to be sure it is right where you want it to be. Don’t be in a big hurry……. be sure of what you want to do.  Remember, once you fire up that iron, it’s in your hands now and not ours. We are not obligated to replace it if you BOO BOO.   Soooooooooo……. TAKE YOUR TIME.

The manufacturer says it’s suitable for white or pale pastel cotton fabrics.

Using an Iron set on its hottest setting (approx 160 C) with NO STEAM, iron the whole image, using firm pressure for about 20 seconds on each pass for 2-4 minutes, depending on the size of the iron on. Don't forget edges and corners.

 Let it cool for about 1 minute.

Remove the backing material slowly and evenly.

Washing: Do not wash for 72 hours after ironing. It is machine washable, just use cold water and  turn t-shirts inside out to wash.

Dry at low temp setting. Do not dry clean. Do not iron on the printed image.

NOTE:  These helpful tips are NOT to be used in lieu of the actual instructions provided with the iron on transfer. If there is any question, follow the manufacturer’s instructions.