FORD 3 Button Transponder Remote Flip Key for BF FG Falcon Territory Mondeo FPV

   1.  Program the remote control part to your car. 

                       ( you can do it yourself if  got 1 original key, Programming Guide is in the listing)

                    2.  Get the key blade cut by locksmith or key cutting shop

  3. Program the transponder chip into your car. 

                                                    ( you can do it yourself if  got 2 original key, Programming Guide is in the listing)

                         If you only have 1 original key, ask Ford dealer or locksmith to program the key for you.

1 remote part programming instruction

To program the remotes you will need to have all the remotes available for the car as you need to relearn them all. 

we will start with remote 

  1.Sit in the car with the doors closed 

  2.Turn the ignition to the ACC postition and press the rear demist button 3 times, within 5 seconds.

  3.You then press a button on the first remote to be trained , the door locks will cycle.

  4.Then press a button on the 2nd to be trained and the door locks will cycle again. 

  5.Repeat this step for the the rest of the remotes to be trained to the car. 

  6.The first keypad trained will result in one door lock cycle, the second will result in 2 door lock cycles, and so on.

  There is a limit of 8 remotes per car. 

  7.Turn the ignition to the OFF position to exit the learning mode.

   Your remotes are now programmed to your car.

2 Key Programming 

You will need to have 2 orginial keys available if you wish to program the transponder chip with  the below instruction.

If you only have 1 working key it will need to be programmed by dealer or locksmith (the procedure listed below will not work)

 ensure you have all keys present during recoding as any key not present will be removed from the memory.

1.please sit in the drivers seat with doors closed and put the first coded key into the ignition & turn to the ACC position. 

2.Now please turn this key to the OFF postition & remove the key.

3.Within 5 seconds put the 2nd coded key into the ignition & turn this key to the ON postition.

 4.Turn this key back to the OFF postition and remove the key.

5.The door locks will then cylcle to indicate that the learning mode is active.

6.Within 5 seconds put the new 3rd or new key into the ignition & turn to the ON postition. 

7.The door locks will cycle 3 times to indicate the 3rd key has been trained ,

 ensure you wait for the locks to finish cycling before turning the key to the OFF position.

 8.Repeat this step for any following keys , The 4th key trained will cycle the locks 4 times,

 and so on. you can train up to a maximum of 8 keys.