Each of our Multistar Prop Adapter Sets are CNC machined from billet aluminum.  These adapters have a 6mm shaft and will bolt on to the popular Multistar 2209 V2, 2213 V2, and 2216 V2 brushless motors used in many multirotor applications.  This is an upgrade to the smaller 5mm shaft that comes with these motors.

This adapter set includes 2 right hand thread (CW) and 2 left hand thread (CCW) adapters.  The 6mm shafts will allow a large variety of plastic, carbon fiber and DJI self tightening propellers to be used on these motors.    Each propeller will be self tightening while the motor is powered.

The adapters are very light and much stronger than the stock ones giving you the confidence needed for worry free flying. 

Installation is quick and simple with no modifications necessary.
 

Two step installation:

1. Install prop adapter onto motor using the supplied socket head screws.
    
2. Install propeller onto adapter followed by the M6 washer and tighten with the M6 Hex Nut.
   (Or you can use our M6 Spinner / Prop Nut Set )
    

Included:  4 - Multirotor 2x6x12 Prop Adapters (2 right hand thread / 2 left hand thread)
              16 - M2 x 5mm socket head screws
              2 - M6 right hand thread hex nuts, 2 - M6 left hand thread hex nuts, 4 - M6 Flat Washers
 

Weight (single prop adapter only):  2.9g
 

Dimensions:

• Shaft Diameter:  6mm
• Shaft Thread:  M6x1.0  (2 right hand thread and 2 left hand thread)
• Shaft Length:  15.2mm
• Base Thickness:  4.5mm
• Bottom Side Hole:  2mm dia x 5mm deep
   

Notes:

This adapter set will only work with the V2 motors that have 4 mounting holes

When replacing props it is recommended to check the current (amp) draw with a watt meter so the motor or ESC amperage rating is not exceeded.

Adapter screws should be checked and tightened as necessary.  A drop of blue (removable) loctite can be applied to the 16 screws before installing the adapter.

Motor and props not included.