Surface Mount D-Ring 20-Pack 

4,000 lb.cap.*


This listing is for TWENTY (20) tie down attachments.

The strong surface mount d-ring has a 4,000 lb. vertical pull weight rating*. The ring is welded together, not pressed. It's gradual taper creates a low profile tiedown attachment rising only 3/8" off the floor.

This steel attachment is zinc coated to inhibit corrosion. To obtain maximum strength it is recommended to install these d-rings with bolts, lock nuts, and fender washers (wide diameter). 

These surface mount D-rings are also available with Backing Plates.



SPECIFICATIONS:

  • 4,000 lb. rating (straight pull). WLL is 1,333 lb. capacity*. 
  • This attachment measures 3-3/4" wide x 5" long.   
  • The 1/4" diameter ring measures 1-1/2" wide x 2" long. 
  • The "top cap" is 11 gauge or 1/8" thick. 
  • The tiedown attachment is secured with one 3/8" diameter mounting hole and a 1/4" rivet.
  • 1/4" drain hole.

     

    *RATED CAPACITY: Also known as "assembly capacity" or "break strength" is the minimum load a complete assembly can withstand before failure in a laboratory pull test when the product is NEW.

    WORKING LOAD LIMIT: The maximum load weight a tie-down should be subjected to during normal use. To assist in making the proper tie-down choice the Federal D.O.T. requires the W.L.L. to be 1/3 of the Rated Capacity.

    Please contact us at 856-374-4740 with any questions or comments.

    Telephone customer service hours: Mon-Thurs 7am-9pm EST Fri-Sat 7am-5pm