4 of Melt-blown Polypropylene Sediment filters – Sediment filter is often the first filter installed in the Reverse Osmosis circuit. Sediment filters are made of fine melted polypropylene, which is then blown and spun in a cylinder-like form. The main function of a sediment filter is to remove large and fine particles from a drinking water, such as sand, dirt, silt, and rust particles. Removal of such particles allows for a better performance of all the following filters, such as Carbon Block or GAC filters.

Micron rating: 5 Micron.
Dimensions: 10" x 2.5"
Lifetime: Replace two or three times a year, depending on the water quality.

This filter is wrapped and sealed and meets NSF Standards and Regulations. Filter will fit any Residential Reverse Osmosis Unit that features standard 10” filter housing

4 of Block Activated Carbon filters – Block Carbon Filters are similar in their performance to that of GAC filters, being made of fine coconut shell carbon they also do remove odors and tastes of many organic compounds, chlorine especially. Though, because this filters are made of a packed carbon (forming a cylinder block), they offer a much finer filtration of suspended particles and dirt.

Micron rating: 5 Micron.
Dimensions: 9.875" x 2.5"
Lifetime: Replace two or three times a year, depending on the water quality.

This filter is wrapped and sealed and meets NSF Standards and Regulations. Filter will fit any Residential Reverse Osmosis Unit that features standard 10” filter housing

4 of Granular Activated Carbon filters (GAC) – GAC filters are well-known for their highly efficient reduction of chlorine taste and odor, as well as other taste and odors of many organic chemicals and volatile organic compounds. All GAC filters are made with high quality coconut shell carbon.

Micron rating: 5 Micron.
Dimensions: 9.875" x 2.5"
Lifetime: Replace two or three times a year, depending on the water quality.

This filter is wrapped and sealed and meets NSF Standards and Regulations. Filter will fit any Residential Reverse Osmosis Unit that features standard 10” filter housing

4 of 6W Ultraviolet Light Bulbs(GAC) – Kills harmful Bacteria, E Coli, Viruses Fungi, Algae and most microorganisms including cryptosporidium and giardia, and many other contaminants.

Product Features

• Capacity: 1 GPM
• Length: 12"
• UV lamp: 6W
• Voltage:110v
• UV Lamp Life: 9000 hours (about 1 year)

2 of Inline Granular Carbon Filter is also known as polishing filters, because they would usually be the last stage of any standard Reverse Osmosis circuit. Being made of high quality coconut shell carbon they stabilize the water tasting qualities and further remove any traces of bad tastes and odors.

This filter is wrapped and sealed and meets NSF Standards and Regulations.

1 of 100 Gallon per Day NSF Certified Thin Film Membrane – TFC Membrane is the main component of any Reverse Osmosis Unit. Made with fine thin film flat sheet, a membrane provides up to 98% reduction rate of bacteria, pesticides, herbicides, and heavy metals from tap water. The micron rating of a thin film membrane is less than 1/10000th of a Micron, which is at least 5 times smaller than any known bacteria. Such precision allows for highest rated reduction levels and ensures the top quality of pure drinking water.

Product Features:

• 100 Gallons Per Day (15.8 Liters per Hour) Capacity
• 98% Stabilized Salt Rejection (Minimum Rejection 96%)
• NSF/ANSI Standard 58 listed

Operating Conditions
Performance specifications based on 500 ppm tap water, 50psi (0.35 MPa) applied pressure, 77°F (25°C) feed water temperature, feed water pH 7-8 and 15% recovery. Element permeate flow may vary ± 15%.

• Maximum operation pressure: 125 psi (0.86 MPa)
• Maximum feed flow rate: 2 gpm
• Maximum operating temperature: 113° F (45° C)
• Maximum feed water turbidity: 1 NTU
• Maximum feed water SDI (15min): 5
• Chlorine tolerance: 0
• Feed water pH range: 2-11
• Minimum brine flow to permeate flow ratio: 4:1