Wrench is NOT included.

Stops are ONE INCH wide.

This stop can be used from the left or right hand side.

The pins are both set BELOW the vise jaw.

This lets you machine the edge of any part right down to the jaw.

These are very useful in any kind of set up where you do not want to hit the stop itself with your tool.

All vise stops are inspected and tested for use. As positive feedback is very important to us, please contact us if you have a question or problem.

 Stops will adjust to any standard vise jaw up to 1.05" inch thick.

 The pictures show a 6 inch Kurt and a 4 inch Kurt.

Thank you! and keep us in mind in the future. 

Please check out our other tools (in the last picture) including aluminum clamps up to 3 inches long !