With FC, OSD, PDB all integrated, Kakute AIO makes it simple and
convenient to build up your drone.Only one VTX module is needed to make a
complete set of FPV Racing Drone.Minim OSD integrated; MWOSD Firmware
preloaded; OSD Config port available; OSD interface highly customizable
according to you own needs.
2 oz Copper PCB ensures the 120A Maximum Continuous Current.Dedicated
Boot button for easy firmware flashing.Reinforced solder pads for
trouble-free direct soldering.Extremely low profile design.
Input voltage 7v to 42v. Power the board directly from flight pack up to
6S (on 'BAT' pad only!).PDB Maximum Continuous Current 120A.VIN + VBAT
merged - A single wire to power the board will provide voltage input and
Telemetry/OSD voltage data.Filtered voltage output - output 5v 800mA
(and 3.3v 150mA where applicable) to power peripherals such as GPS, RX,
BLACKBOX. 5v/3.3v RX selectable.
Cleanflight support (RACE target).BLHeli flashing supported by hardware.Raceflight ready.Betaflight ready
STM32F303CCT6(256kB flash) 32-bit processor
MPU6050 Gyro/Accelerometer
ATmega328P with Arduino Bootloader(minim OSD)
MAX7456 Monochrome On-Screen Display(minim OSD)
FTDI Cable Compatible Pinout(minim OSD)
High quality, gold plated PCB
Micro USB connector for programming
Dimensions: 36x47.5x7mm (includes USB in height)
Mounting Holes: 30.5mm square to center of holes
Weight: 7g