Approx Fitting Time: 60-90 Minutes
- Remove old ABS Sensor.
- Clean ABS Sensor Tube thoroughly.
- Generally there is no need to remove the driveshaft fully from the vehicle, this process can be achieved in situ.
- Firstly, you need to remove the old ABS Ring from the Driveshaft / CV Joint by drifting off.
- Clean the Driveshaft / CV Joint using a wire brush / emery cloth to remove ALL loose corrosion. DO NOT grind / file or clearance will be lost.
- Apply some pd ABS Ring Retaining Compound to Driveshaft / CV Joint. (supplied FREE OF CHARGE with all of our ABS Rings & ABS Kits)
- Drift the new ABS Ring into position.
- Allow to cure (approx 10 Mins).
- Re-assemble using new Hub Nut. (supplied FREE OF CHARGE with most of our ABS Kits)
- Fit new ABS Sensor. (supplied with our ABS Kits)