TOP QUALITY WINDOW TINT FILM

LIGHT BLACK 40% LIGHT

TRANSMISSION  60% DARKER TINT

1 x ROLL 3m x 76cm

+ FREE FITTING KIT

FITTING INSTRUCTION:

IMPORTANT:

The film must be separated from its transparent protective layer

this is best done with 2 small pieces of scotch/adhesive tape/ sticked

on both sides of one of the corners of the film and this will reveal its adhesive side,

please apply it on your window with plenty of soapy water on the glass,

then press with the plastic tool (to avoid scratching the film please

do not press too hard with the plastic tool or better wrap it in some cloth).

Thanks  

1. Clean window inside and out with soapy water. NO AMMONIA

2. Cut film pattern on outside of glass. LINEAR SHOULD FACE OUTSIDE

3. Trim film to fit on outside of window

4. Spray a light film of water on glass and film

5. Peel film apart from backing on inside of window. Use two pieces of transparent tape to separate film from liner

6. Spray adhesive with soapy water solution

7. Place film on INSIDE of window

8. Spray film with soapy water solution and squeegee firmly

9. Trim film with new sharp blade, leaving 1/16” gap around edges

10. Spray film with soapy water solution and squeegee firmly

11. Drying time 3 days in full sun

 Thanks for Looking!

The United Kingdom sets minimum light level requirements for vehicle window tint. Please make sure you follow these requirements: https://www.gov.uk/tinted-vehicle-window-rules