|
|
FALCON 3D PARTS ON EBAY
|
|
Running Engine Lights for DeAgostini Millennium Falcon |
|
|
The listing is for "running engine" lights for deAgostini Millennium Falcon. Each set consists of 12 Neopixel RGB super bright LEDs attached to Trinket Pro - Arduino compatible controller board. (Neopixel is a registered trademark of Adafruit inc. We only sell genuine products.) The controller gradually independently changes brightness of each LED creating a look of "in-flight" mode. Once the power is supplied to the board, the controller goes through a "start-up" sequence turning ON the LEDs one by one and then switches to "in-flight" mode that runs indefinitely, until the power is turned off. The LED strips connect the same way the stock LED strips are connected to the circuit board of the ship. You can see the strip is overlapping with the edges of the housings. This is done on purpose.No modification of any existing wiring or parts is necessary however to avoid "light gap" in the middle you can either file down the edges of the housings, or if you don't want to make any changes into the original parts of Millennium Falcon, you can cut off with scissors one LED from each strip. If you are planning to use this for any other model, any power source from 6v to 12v will work. The controller also has protection from reversed polarity. |
|
Please note, you need 2 sets for deAgostini Falcon and Hasbro Falcon. You might be able to use just one set for 1/72 and 1/144 versions of the ship. The LED strip can be cut to length if needed.
|
|
|
|
|
|
Example of the lights set in Hasbro Hero conversion |
|
Thank you for checking out my listing! Please let me know if you have any questions. |