The professional's choice of asphalt / tarmac restorer from the company who’s got it covered .....
* One coat application
* Fresh layed finish
* thermoplastic acrylic polymer fast dry technology
* Environmentally friendly
* Easy to apply
* Available in a choice of Black, Red, Green,Blue,also
White and yellow line marking
Suitable for use on any worn Asphalt or Tarmacadm surface. Provides 8m square coverage per Ltr. Coverage rate will be dependent on the surface conditions.
PRODUCT DESCRIPTION
* Water based thermoplastic acrylic polymer Tarmac Repair coating, environmentally
friendly easy to apply product
* Top up coats Of Tarmac sealer can be applied at any time
* Reduces Tarmac stone loss and increases the life span of the Tarmac driveway's
* Waterproofs, re-colours and protects Tarmac
* Helps Resists oil, grease and dirt stains
* Resists fungicidal and algae growth
DETAILED
Thermoplastic acrylic polymer Tarmac sealer is a superb easy to apply Tarmac restorer designed to rejuvenate and transform tired old tarmac.
Tarmac thermoplastic acrylic polymer is far superior to a tarmac paint and offers a cost effective alternative to replacement of driveway.
* Transform the appearance of any existing Tarmac Driveway/Walkway/Car-Park
* Replaces lost resin from Tarmac, vastly superior to bitumen based tarmac paint
* 20 litre drum, average coverage 120 sq metres (surface condition can affect this rate of coverage)
* Easy to apply with roller
* Re-creates original colour of Tarmac
* Avoids need for expensive replacement of asphalt
* Long term protection, reduces future Tarmac repair
* Covers unsightly cement & oil stains or marks
SURFACE
Surfaces should be dry and free from dirt, Grease and all other contaminants.
Always apply a test patch before coatings a
whole area
APPLICATION
After 5 minute activate mix apply onto the surface using roller or brush. Since the product dries by evaporation of water it should not be applied under conditions of high humidity or where there is a risk of high condensation during the drying period.
DRYING TIME
(At 15-20 Degrees C) Surface dry approx 2 hours. Overcoating minimum 8 hours, These times will be extended at lower temperatures and also in conditions of high humidity.
THEORETICAL COVERING CAPACITY
6 sq. m/litre at 60 microns dry film thickness. Please allow for wastage and surface porosity
CLEANING
Clean by using tap water do not empty product or brush resadue in to drains or watercouses
Supplying the best quality products to the uk & Europe at the best prices and service levels
ONLY APPLY WHEN DRY AND FREE FROM RAIN/OIL/DIRT
Oily / Contaminated Surfaces
Where the floors have been subjected to oil and grease, We recommend steam cleaning your floors and use Marl Coatings Heavy Duty Surface Deep Clean before application of any floor coating, after allowing the surface to dry and Marl Coatings Pre Seal has been applied a top coat can then be applied please do test patches on each stage of this process.
Rising Damp
A floor coating does not do well if you have any moisture issues Hydrostatic pressure from the moisture can actually cause the coating to peel up, sometimes taking pieces of the concrete with it. Should floors be devoid of an effective Damp Proof Membrane (DPM), virtually any paint will lift and peel off the surface. Indeed, even self-levelling screeds can be pushed up by water pressure. This is another nightmare regularly experienced by many companies. For this reason, a damp-proof coating is recommended as a solution before applying a floor paint.
Treating your floor before coating them
It is important to treat your surfaces before coating them to prevent issues post-paint.
Repair your floor:
Before painting your garage floor, it is important to repair any cracks, holes or expansions of joints in your concrete to prevent an un-slightly finish to your flooring once its painted.
Product & Application information:
Product coverage rate:10m squared per litre or 107ft squared per litre
5 litre pack size should achieve 30m squared per 5 litre can
10 litre pack size should achieve 60m squared per 10 litre can
20 litre pack size should achieve 120m squared per 20 litre can
(Two thin Coats Always Advised giving adequate dry time between coats)
Dry time of coating using standard roller in areas with minimal air moisture (lab conditions)
Touch dry @ 15'c = 10/12 hours
First coat should be left to dry for 24 hours to assure adhesion to surface leave minimum of 24 hours for after coats always leaving minimum of 48 hours before 100% use of area again
true 100% cure will only be 7 days after application of last coating
Dry time of coating using standard roller in areas with minimal air moisture (lab conditions) touch dry @ 15'c = 10/12 hours first coat should be left to dry for 24 hours to assure adhesion to surface leave minimum of 24 hours for after coats always leaving minimum of 48 hours before 100% use of area again
true 100% cure will only be 7 days after application of last coating
Work in a well ventilated area,using no forms of naked light/fire please test for damp before coating by applying a small test patch or applying a clear plastic sheet (30cmx30cm) and sealing it to the floor with a high grade tape (duck tape) with out any ways of air escaping and leave for 24 hours if there is any forms of water vapour on the sheet the are will have damp and steps will need to be taken before coating
Mix very well before use using a drill/paddle tool If the area you are looking to coat is virgin (never been coated) or has had contamination from oil,grease,cutting agents etc,Cleaning with correct equipment/surface preparation products will be required. The area will then need to be coated with a heavy duty pre seal and left to dry for 24 hours (you can purchase this pre seal on the drop down menu) Powerfloated/Screed areas (smooth shinny concrete) will need to be treated with a acid etch or abrade by mecanical means all product info will be displayed on the item you will take collection of a test patch is always advised as some areas my still have contamination and this could have complications when coating product weight 25kg minimum
Shipping Information: we do not deliver to Northern Ireland, all of Isle of Wight, Isle of Man and Isle of Scilly and The Highlands and Islands and also the following area postcodes:- DD, DG, EH, FK, KA, KW, KY, ML, TD, AB,PA,PH (95% of these postcodes are 3/4 day service and priced at £12.99 per item) IMPORTANT:TO ENSURE DELIVERY EFFICIENCY A CONTACT NUMBER IS REQUIRED AT TIME OF PURCHASE please add number to "add note"on paypal page just before clicking to paythe delivery company will only try twice to deliver the goods(leaving a calling card to rearrange delivery both times) if no one is at the address or do not contact them the item we be returned to us A refund will be made deducting a £9.99 return fee (standard fee) Scotland may be more all vans have cctv and tracking info for proof of delivery attempt Other Important information:
PLEASE make sure enough product is ordered at time of purchase or keep a note of batch code from lid of can PRE-SEAL ITEM IS A UNDERCOAT/SURFACE SEAL AND SHOULD ALWAYS BE OVER COATED WITH A FLOOR PAINT PRODUCT THE PRE-SEAL PRODUCT ON ITS OWN WILL NOT ACT AS A STABLE FLOOR COATING Floor-paint Products are polyurethane heavy duty high impact formulation and care should be taken when applied full safety data and coshh sheet can be requested
All products are supplied and provided on the condition that we cannot be held responsible in the event they are used for any other purpose than that specified by the manufacturer, We/us/one (my paint lady) shall not be liable to the customer in the event of damage to goods/property, injury to persons resulting from negligent or improper use/application or handling/advice of goods by the customer or their employees
Any recommendations and advice offered are given without legal responsibility. We/us/one (my paint lady) shall not be liable to the customer in the event of damage to goods/property or injury to persons resulting from negligent or improper use/application or handling/or advice of goods by the customer, their employees or their agents or members of the general public, or any loss of profit or contracts or other consequential losses of any kind however caused.
To the extent permitted by applicable law, We/us/one (my paint lady) disclaims all warranties, express or implied, as to the accuracy of the information contained in any of the materials on this website.
We/us/one (my paint lady) shall not be liable to any person for any loss or damage which may arise from advice given or from the use of any of the information contained in any of the materials offered on this website.
We/us/one (my paint lady) reserves the right to dispatch in any pack size available on listing for 20 litre orders we may send 4 x 5 litre packs or 2 x 10 litre packs if stock does not support 1 x 20 litre at that moment we will not contact to advise on this, buyers cannot request this and we do advise buying the correct pack size requested we do always aim to dispatch in ordered amount no extra cost will be to the buyer for this.