TECHNICAL DATA
Gloss Level: Gloss
Propellant: Dimethyl ether
Heat Resistance: 100°C (dry heat), above 65°C discoloration may occur
DRYING TIMES AT 20°C/RH 50%
Touch dry: 15 minutes
Dry to handle: 30 minutes
Dry to recoat: Within 1 hour or after 48 hours
Fully cured: 7 days
Recommended Wet Film Thickness
100 μm
Recommended Dry Film Thickness
25 μm
Theoretical Consumption
2.5 m² per spray can at 25 μm dry
Practical Consumption
Practical coverage depends on many factors such as porosity and roughness of the substrate and material losses during application.
Surface Preparation
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. Prime or spot prime with the recommended RUST-OLEUM Primers. Sand intact coatings to provide a proper key for adhesion. The surface must be clean and dry during application.
Application Conditions
For good results the relative humidity shall be below 85% and the temperature of the can above and substrate 0°C.
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use. Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to achieve adequate coating thickness. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
Notes
Bright topcoats may need a light coloured primer/intermediate coat.
Safety Data
VOC level: 640 - 650 g/l