ARRMA BIG ROCK Crew Cab 3s V3 Skid Plate 2 Piece Set / Roof + Rear Guard Body Protection

You get the Roof Skid Plate and Rear Guard Body Protectors  (2 piece set)

Condition: New Unused Custom Made & 3-D Printed
Colours: Black, Carbon Black*,Carbon Grey*, Red, Blue, Green, Yellow, Purple, Grey, Orange, White
Hex Bolts: Black or Silver

*** If you do not see the colour combination you require - please message. ***

3-D Printed using GEEETECH & TECBEARS PLA (*Carbon Black/Grey uses PLA with  up to 20% Carbon Fibre)
Adds protection to the body shell when they are fitted.

Supplied: Roof Skid Plate + Rear Guard + all backing plates, all hex bolts  & backing nuts.

Measurements (approx.)
Roof Plate
Roof Plate   L: 98mm, H: 9mm, W: 85mm
Backing Plate   L: 80mm, H: 4mm, W: 10mm
Rear
Rear Guard  L: 55mm, H: 7mm, W: 120mm
Backing Plate  L: 55mm, H: 5mm , W: 12mm

Fitting
You will need to make 4 small holes in the shell to mount skid plate & 4 small holes for rear guard.  Use the rear backing plate as a guide for hole location.
For the roof protection do not position rails too far forward, the front door pillars slope away and it leaves a gap between the front of the rail and the roof.

The skid plates and rear guard will scratch-up and wear down, they are not indestructible!

Not Included
Shell 

Disclaimer
All 3D printed objects are susceptible to small superficial surface imperfections such layer lines, tiny gaps, small blobs.  Quality control means each piece is finished by hand and checked before dispatch.  Please see feedback comments for the excellent quality of these pieces.  
PLA printed parts should not be exposed to extreme temperatures as the strength of the product can be compromised (< 10c (50F) > 40c (104F)).