Traxxas Slash 2wd, Bandit, Stampede 2wd, Rustler 2wd RX box/Receiver box. This holds your receiver on the chassis in place of your OEM radio box. It utilizes the original 2.5mm hex screws (hardware) that your OEM box uses.

Instructions:

Fully remove your screws from your OEM RX box when pulling out your receiver.

Swap this BEER cooler in place of your RC Car/Truck original RX box.

Run your steering Servo and ESC/LED wires through the rear knock-out port of the cooler.

Use your original 2.5mm hardware from your old RX box to secure the lower half of this box to your RC car/truck chassis. Then, use your remaining hardware to secure the lid down.