Spider Spit Paint Protection Film Tack Solution
Mix a few drops of Spider Spit with water to make your tack solution, essential for applying paint protection film and wet install vinyl films.
Widely used by professional installers. Appealing scent.
Please note: comes in a plain bottle.
Widely used by professional installers. Appealing scent.
Please note: comes in a plain bottle.
This is a specially created formula for application of PPF and wet install vinyl films.
Contains no particulates, no degreasers, lanolin or harsh chemicals that weaken the performance of your products.
Slips when you need it to and tacks quickly.
Mixing ration: 1 ounce per gallon of water. Distilled water works best!
- 30ml makes approx 3 litres (enough for approx 3 cars)
- 30ml makes approx 3 litres (enough for approx 3 cars)
- 200ml makes approx 20 litres (enough for approx 20 cars)
- 500ml makes approx 50 litres (enough for approx 50 cars)
- 500ml makes approx 50 litres (enough for approx 50 cars)
1. Generously spray Spider Spit solution on desired surface
2. Using a hard card/squeegee, gently apply your vinyl and smooth out any bubbles
3. If material is masked, spray exterior of mask with Spider Spit (wait 60 seconds, then remove the mask)
4. Use a fresh cloth to gently dab the vinyl clean
Ideal for use with one of our pre cut PPF kits.
Not classified as hazardous according to UN GHS criteria
CAUTION - USE WITH AQEQUATE VENTILATION
If the product comes into contact with your eyes, wash with water immediately as a precaution. Wash skin with plenty of water. If the product is heavily inhaled, remove the person to fresh air and ensure comfort when breathing. If the product is ingested, call a poison centre/doctor if you feel unwell.
KEEP OUT OF REACH OF CHILDREN
