|
|
|
Replacement LED "Fluorescent" tubes, Old Fluorescent can be upgraded to modern LED
fittings. For conventional Inductive Ballast Fluorescent fittings it is only necessary to remove the starter. Modified circuit
should be on a RCD / RCBO. With a little re-wiring, In the process you will get more light output for less than half the power.
All units are Non-Dimmable.
See more info below for different wiring diagrams depending on fitting type.
Any Modifications to light fitting should be carried out by an electrician. |
|
There are several tube options -
4000K - Frosted, 120° Viewing angle 4000K - Clear, 120° Viewing angle Tilt / Rotating Adjustable ends for different angle positing
Plain end for straight replacement. 4ft / 1200mm - 18 Watts of LED Power per tube, 184 LED's, 1800 Lumen 2ft / 600mm - 9 Watts of
LED Power per tube, 88 LED's, 900 Lumen
|
- T8 / T10 LED Replacement tubes
- SMD and Lumilux LED's for performance, minimum light deterioration and high colour consistency
- Rotating Ends to suit various lamp holders, Fully illuminated walls
- Full Aluminium casing and PCBs for high heat dissipation to prolong Tube life
- Semi Opal/Clear Lined Polycarbonate diffusers
- 30,000 Hr in Enclosed Fittings. 50000 Hr in Exposed/Louvered fittings
- Works with conventional Switch-Start ballasts without Starters or direct from mains by bypassing Electronic Ballasts. See wiring
instructions.
- Available in other colours including
- CRI >80
|
|
Below effective modified fitting circuit.
|
|
 |
|
Below conventional Fluorescent converted to LED's.
|
 |
|
Below Colour Temperature chart.
|
 |
|
Below typical conventional Fluorescent circuit, Electronic ballast versions will differ.
|
|
|
|
Below Modifications required to a typical conventional Fluorescent circuit, Final Circuit at bottom of listing.
|
 |
