The
Linksys High Power PoE Injector, LACPI30 offers a quick and easy setup with Plug-n-Play installation, provides Power over Ethernet (PoE) capabilities to a Provider Edge (PE) device and to your non-PoE network by simply connecting it to your existing network. It is easy to configure and operate allowing you a fast and convenient access to your files.
It also reduces the wiring cost of AC power by using a standard CAT5 cable to carry both power and data to Power over Ethernet devices such as cameras and access points, up to 100 meters away.
Product OverviewFront
PoE LED (Green) - Indicates the PoE/DATA port delivering power.
- OFF - The PoE/DATA port is not delivering power.
- Solid Green - The PoE port is delivering power.
System LED (Blue) - The LED lights up and stays solid when the switch is powered
ON.
PoE/DATA port - This port supports 10/100/1000 base Ethernet and can transmit power and data at the same time or either.
DATA port - This port supports 10/100/1000 base Ethernet and
ONLY transmits data.
Back Power Socket - AC power in, to connect the power cord to a power source.
Features- Convenient access to Power
Supplies power to PoE Wireless Access Points, IP Cameras and other PoE Powered Devices (PDs) through the Ethernet cable.
- Speed and power performance
Offers Gigabit speeds with IEEE 802.3at (PoE+), which can provide power for up to 30 Watts.
Quick and easy set up - no software required.
Requirements- One Gigabit Data Port - to connect to a switch or hub
- One Gigabit with PoE port - To connect to a Powered Device (PD)
- Internal Power supply - AC power 100-240 V AC at 50-60 Hz
- Indoor usage only
- The minimum power cord length is five (5) feet
PerformanceAll the ports must provide full line rate and forwarding rate of 64 B frames at 1.488 Mpps for 1000 M port, 0.1488 Mpps for 100 M and 0.01488 Mpps for 10 M port.
Enclosure TypeThe Injector is built with a metal chassis.
Wall Mounting The Injector is built for Wall-mounting purposes.