Features:
  • MagCAD GoPro mount for compatible Deda Superzero stems.
  • Replaces the Deda Elementi D-Clip, providing a secure point to attach various out front computer mounts.
  • Weighs just 8 grams without hardware.
The Garmin/Wahoo devices, out front computer mounts and Deda stem pictured are for reference only and not included.

Please note: This mount does not fit the Superbox stem, only the Superzero.

What's Included
  • 1x 3D printed mount.
  • 1x M5x20mm button head screw.
  • 1x M5 dome nut.
Overview
This MagCAD mount attaches to compatible Deda Superzero stems, replacing the D-Clip if already fitted, and allowing for various out front computer mounts to be attached.

The latest Deda Superzero stems have a gap between the handlebar and stem for electronic cables running through. The Deda D-Clip is an aesthetic/aerodynamic Nylon cover that fills this gap.

The design of the MagCAD mount is similar to the Bontrager Blendr system that provides a base point to attach various devices and accessories using a GoPro style lug.

This mount does not fit the Superbox stem which, although uses the same D-Clip from Deda, has a very subtle difference internally preventing the MagCAD mount from fitting.

​Application
To fit the MagCAD mount follow the below instructions. As with any steering related component they should be installed by a competent mechanic and inspected regularly. Incorrect assembly or mis-use may result in damage to the components and/or injury.
  1. It is recommended to record/mark the position of the installed handlebars so they can be reinstalled in exactly the same position. This can be done with a non permanent pen or tape.
  2. Loosen and remove the stem faceplate bolts and two piece faceplate, noting their position and orientation.
  3. Pull the handlebars forward slightly.
  4. If the Deda D-Clip is fitted, remove it. It will not be required.
  5. Install the MagCAD mount over your handlebars with the GoPro lug at the bottom. This can be done to one side or the bars if the cross section is smaller or in the centre or the bars, taking care not to over stretch the mount.
  6. Reposition the handlebars in the stem, ensuring the two open ends of the MagCAD mount locate inside the stem.
  7. Reinstall the stem faceplate and torque the bolts as per the manufacturers instructions. The two pieces of the faceplate are sided so must be installed in the correct position and orientation.
  8. Check the MagCAD mount feels secure with no movement.
  9. Fit a compatible out front computer mount or accessory, not supplied.
Please Note: We recommend using a tether for any device you attach, just for extra security.

Material
MagCAD Mounts are 3D printed in Nylon PA12. However these are not your typical home 3D printers. Following a process of SLS (Selective Laser Sintering) on industrial size printers, costing anything above £100k, the resulting mounts have fantastic resolution and refinement. The surface finish is slightly rough with a matte effect and the performance of the mounts are comparable to injection moulded parts.

Customisation
As with all MagCAD items it's more than possible to tweak or change the design to suit your particular installation. Feel free to get in contact for more details.

About Me
I’m a MEng Aerospace Engineer and former professional cyclist. All the items, including this mount, are ones which I’ve developed and use myself. A hobby which I take too far but want to share with others.

Delivery
All items in stock and dispatched promptly, usually the same day.

Returns
Should you have any issue or just change your mind we're happy to accept returns within 30 days, providing the item is unused.