Made for audio - video equipment, but has unlimited uses as a pushbutton indicator switch.

PC board mount, non-tactile switch has a 17.4mm square white diffuser lens top, that glows a nice red or green color, depending on what LED is powered. LED is a 3 lead, common anode, bi-color LED. LED leads extend out bottom of switch, and are independent of switch contacts. You decide how to power them.

As shown in the last photo below, ANY COLOR between red and green can be generated, by varying the relative current between the LED's.

Switch contacts are SPST normally open contacts, which close as long as button is held down. Contacts are gold plated, rated 100 ma @ 12 VDC, and rated for 5 MILLION operations! Extremely reliable, and highest quality made by NKK.

Size of body approximately 0.9" Tall x 0.6" square.

These type switches can sell for over $20.

Keep watching our other listings for possible different quantities, and a smaller lens NKK switch.

The seller makes no representation of any item(s) sold to be fit for a particular purpose and assumes no liability for its use or misuse. It is assumed that the unit(s) will be installed and operated by qualified personnel. The purchaser agrees that the seller shall not be held responsible or liable for any injuries or damages, whether incidental or consequential, associated in any way with the item(s). 

Lot of 10 pieces.

NOTE: It was very difficult to photograph these switches when illuminated. At normal illumination levels, the camera picks up a yellow/orange color, rather then red color. None of the illuminated photos do the parts justice, the illumination looks much better in real life.

At normal illumination camera picks up red color as orange, actual color is red as shown below.

ANY color between red and green can be generated, by adjusting the relative current between the LED's.
Yellow is shown above. Center is solid yellow, camera is picking it up as slightly white.

Insert your own image, symbol or graphic under top cap. Cap removes easily for insertion.