60mm Single Wall Stove Flue Pipes

This flue pipe and accessory set will fit Little Burners: Little Lenny, Lenny Burner & Florence. Our 76mm flue kit will also fit Lenny, Little Lenny & Florence. 60mm fits internally and the 76mm fits externally.

Internal Cover Plate
  • 150mm x 75mm (x2), 70mm hole diamater for flue pipe to sit through. 8 screw holes (4.5 diameter), black screws included.
  • 0.8mm mild steel - powder coated black.

Rain Cap
  • 6x Nuts and bolts included.

Operating temperature - Rubber Silicone Boot

  • Safe operating 200° degrees - Max 225 ° (Short period of time).
  • A flashing kit should be installed with a minimum distance of 110-120cm from the stove to allow sufficient cooling.
  • Always wear gloves when installing the kit. May have sharp edges on the inner plate.
  • We recommend cutting the product 20-30% smaller than the pipe to ensure a perfectly tight seal
  • Silicone boot image is for illustration purposes only - the boot will be square/circle but their performances are the same.


76mm Single Wall Stove Flue Pipes

This flue pipe and accessory set will fit Little Burners: Little Lenny, Lenny Burner & Florence.

Internal Cover Plate
  • 250mm x 125mm (x2), 80mm hole diamater for flue pipe to sit through. 8 screw holes (4.5 diameter), black screws included.
  • 0.8mm mild steel - powder coated black.

Rain Cap
  • 6x Nuts and bolts included.
  • 3x legs.
  • 1x hat/cap.

Operating temperature - Rubber Silicone Boot

  • Safe operating 200° degrees - Max 225 ° (Short period of time).
  • A flashing kit should be installed with a minimum distance of 110-120cm from the stove to allow sufficient cooling.
  • Always wear gloves when installing the kit. May have sharp edges on the inner plate.
  • We recommend cutting the product 20-30% smaller than the pipe to ensure a perfectly tight seal
  • Silicone boot image is for illustration purposes only - the boot will be square/circle but their performances are the same.

We do not accept any liability for loss or damage incurred by the use of the flashing kit howsoever caused.   

Please note that fittings do not provide a watertight fit. High heat seals, tapes, and lubricants should be used when fitting to prevent water from entering.