Replacement Waterslide decal kit for Campagnolo

Replace worn or missing decals, or apply to restored parts.

Decal kit is as pictured in the first picture (the other pictures are examples of similar decals applied to some parts.

The kit is as per the first picture, with enough decals for a full groupset plus a few spares.

Decals are extra thin, with edges barely visible especially if you clearcoat over them.

You can use these decals on cranks crankset derailleur shifters levers brakes calipers etc.


NOTE. See other listings for other versions, record, chorus etc.



Installation instructions.

* cut out each decal with scissors.

* clean surface of part well.

* place decal in water for about 30 seconds

* remove from water with backing paper still in place, and place onto the surface of the part.

* slide the decal off the backing paper (slide the backing paper out from under the decal) take care to keep the decal flat on the surface of the part.

* while still wet you can carefully move the decal into its final position

* wipe away excess water, you can use a cloth or sponge, be gentle and take care not to crease the decal.

* allow to dry for at least 3 hours

* to improve durability you can also heat the item in an oven @80deg. C for approx 30mins and  / or apply a polyurethane clear coat.