The LT60 60nm 12 RPM is suitable for larger roller shutters and awnings.
To be used in tube from 70mm to 102mm
Parallel wiring of motors is prohibited without the use of an isolation controller, eg. 4AC Motor Controller,
4 Motor Group Controller, etc. Direct switching of a 230V motor must always be done via a mechanical interlock.
When using this motor as a replacement for a defective motor:
- Don't cut the power cord. It can easily be taken out by loosening 3 screws, so just plug it into the new motor
- Re use the crown and drive from the old motor if you can. (click here to see a video on how to remove them, click here for the video on how to put them back on the new motor)
Technical Information
ELECTRICAL | |
|---|---|
| Consumption during operation | 240 W |
| Minimum voltage | 207 V |
| Maximum Voltage | 244 V |
| Rated current | 1.05 A |
| Nominal Voltage / Frequency | 230V - 50Hz |
MECHANICAL | |
|---|---|
| Capacity of the limit switch unit | 35 turns |
| Type of limit switch unit | Quick limit switch |
| Nominal Speed | 12 rpm |
| Nominal Torque | 60 Nm |
| Repeatabilty | ± 5 ° |
STANDARD | |
|---|---|
| Approval | RCM |
| Protection Index | IP 44 |
| Insulation class | Class I |
CABLE | |
|---|---|
| Plug in cable | Black LT Plug |
| Cable type | PVC |
| Wire section | 0,75 mm² |
| Color | White |
| Wire Length | 2,5 m |
| Number of wires of the cable | 4 |
DIMENSION | |
|---|---|
| Length (L1) | 620 mm |
| Basic crown for tube diameter | 60 x 1,5 mm |
| Weight | 3,92 Kg |
| Overall length (L3) | 614 mm |
| Riveting position distance (L2) | 597 mm |