• Compatibility Vehicle:
  •  
  • 2002-2004 Infiniti I35
    2000-2003 Nissan Maxima
    2003-2006 Subaru Baja
    1993-1996 Subaru Impreza
    1995-2004 Subaru Legacy
    2000-2004 Subaru Outback 
  • About Blower Motor

    • Front HAVC Furnace Blower Motor For 2002-2004 Infiniti I35 2000-03 Nissan Maxima

    Compatibility Vehicle:

     

    2002-2004 Infiniti I35
    2000-2003 Nissan Maxima
    2003-2006 Subaru Baja
    1993-1996 Subaru Impreza
    1995-2004 Subaru Legacy
    2000-2004 Subaru Outback

     

    About Blower Motor

    The blower motor in a car is a small electrical motor located inside the vehicle’s heating and air conditioning duct. The blower motor works in conjunction with the heater core by drawing air from outside the vehicle and blowing it across the core. This heated air is then used to warm the passenger cabin. The blower motor on your car may fail with little or no warning, but if you notice your heater is underperforming or you hear a grinding or scraping noise coming from the firewall on the passenger side of the vehicle, it could be a sign that the blower motor will soon need to be replaced.

     

    How to Replace Blower Motor?

    Step 1:Disconnect the ground cable from the negative battery terminal. Loosen the retaining bolt using a wrench. Pull the clamp off the terminal.

     

    Step 2:Locate the blower motor. On most vehicles, it will be located inside the engine bay along the firewall on the passenger side of the vehicle. On some vehicles, it may be located inside the passenger compartment, below the dash on the passenger side of the vehicle.

     

    Step 3:Pull the wiring connector or connectors off the blower motor, using your hand. In most cases there will be one plastic connector. If there are more than one, use masking tape and a marker to label them for reassembly.

     

    Step 4:Using a socket, unscrew the screws that secure the blower motor to the heater case or firewall. Pull the blower motor and fan blades from the vehicle as an assembly.

     

    Step 5:Replace new Blower Motor, Installing the Blower Motor.

     

    Step 6:Slide the motor/fan blade assembly into position in the heater case or firewall. Screw in the screws that secure the blower motor to the heater case or firewall.

     

    Step 7:Press the plastic wiring connector onto the back of the blower motor.

     

    Step 8:Reconnect the ground cable to the negative battery terminal. Slide the clamp over the terminal and tighten the retaining bolt with a wrench.

     

    FAQ Anwser

    1.About shipping: We have two warehouses in US, one is located in CA, and other one is located in GA. We will dispatch packages from the nearest in stock warehouse by recipient's address accordingly. Up to 99% Orders could be shipped within 24 hours after payment completed. 

    2.About incompatibility parts received: Please provide us with detailed vehicle information including Year/ Made/Model/Trim and Engine, or VIN#. With these information, we could try to help to find out a correct OE# part or exchange a right one for you if we have it in stock.

    3.About damaged package: Please take some photos of the damage part and send to us, we will inspect it carefully and confirm with engineer if the damage will cause functional or installation issues or not. For serious damage radiator, we could do resend a new one or issue refund as compensation. 

    4.About shipping method: UPS, FedEx, USPS are available here and we will choose one of them according to the part you order, for generally speaking, the delivery time is about 3 to 8 working days.

    5.Why choose us: Professional auto parts seller, Premium Quality Products, Excellent service, Satisfactory shopping experience.

     

    6.Other questions: Please message us before order.

     


    Item Specifics
    Brand Autocoolinghome
    Manufacturer Part Number 700050
    Condition New
    Warranty 1 Year
    Interchange Part Number 700050,A/C Fan Blower Motor
    Other Part Number 27220-2Y910,72223AE000,ECM Motor Blower A/C Fan
    Superseded Part Number 72240FA000,Heater Blower Motor
    Custom Bundle No
    Fitment Type Direct Replacement
    Housing Material ABS Plastic
    Placement on Vehicle Front
    Shaft Type Single Shaft
    Product Type Blower Motor w/ Wheel Cage
    Applicable Regions US
    Motor Material Metal

    PAYMENT

    Paypal are the accepted forms of payment.

    Please use the eBay checkout system when paying for your order. 

    SHIPPING

    We have two warehouses in US, one is located in CA, and other one is located in GA. We will dispatch packages from the nearest in stock warehouse by recipient's address accordingly. Up to 99% Orders could be shipped within 24 hours after payment completed. 

    ​UPS, FedEx, USPS are available here and we will choose one of them according to the part you order, for generally speaking, the delivery time is about 3 to 8 working days.

    Shipping services only cover 48 states and Washington DC in US Continental, while most of the time Alaska, Hawaii, Puerto Rico, American Samoa, U.S. Virgin Islands, Northern Marianas, Guam are not deliverable. USPS PO Box, APO Army Post Office, FPO Fleet Post Office addresses are not available

    Your auto parts sometimes might be shipped with two or more separated packages due to weight limitation, please keep patient with no Item Not Received claim or Return request filed until by all of your items are received.

    WARRANTY

    3 YEARS WARRANTY

    RETURN

    All of our brand new items come with a 60-Days money-back guarantee.

    We will replace the defective items, provided that they are in stock within the warranty period posted with the listing and the buyer return the original item and pay for the S&H cost for the replacement

    We will refund the purchase price if the replacement is not available or buyer prefers a refund and send the original item back at his/her own cost. 

    Man-made damage by abuse or wrong operation is not covered by this warranty.

    Refunds will be credited within 1 to 5 business days of receiving the return. 

    ABOUT US
    1. Any Questions Please Message Us Before Order

    Shop Category
     Store Home
     Radiator
     Condenser
     Radiator Support
     Blower Motor
     Motor Resistor
     Cooling Fan & Kits
     Fan Clutch
     Evaporator Core
     Heater Core
     Thermostat
     Radiator Tank
     Suspension Kits
     Other
    Front HAVC Furnace Blower Motor For 2002-2004 Infiniti I35 2000-03 Nissan Maxima

    Compatibility Vehicle:

     

    2002-2004 Infiniti I35
    2000-2003 Nissan Maxima
    2003-2006 Subaru Baja
    1993-1996 Subaru Impreza
    1995-2004 Subaru Legacy
    2000-2004 Subaru Outback

     

    About Blower Motor

    The blower motor in a car is a small electrical motor located inside the vehicle’s heating and air conditioning duct. The blower motor works in conjunction with the heater core by drawing air from outside the vehicle and blowing it across the core. This heated air is then used to warm the passenger cabin. The blower motor on your car may fail with little or no warning, but if you notice your heater is underperforming or you hear a grinding or scraping noise coming from the firewall on the passenger side of the vehicle, it could be a sign that the blower motor will soon need to be replaced.

     

    How to Replace Blower Motor?

    Step 1:Disconnect the ground cable from the negative battery terminal. Loosen the retaining bolt using a wrench. Pull the clamp off the terminal.

     

    Step 2:Locate the blower motor. On most vehicles, it will be located inside the engine bay along the firewall on the passenger side of the vehicle. On some vehicles, it may be located inside the passenger compartment, below the dash on the passenger side of the vehicle.

     

    Step 3:Pull the wiring connector or connectors off the blower motor, using your hand. In most cases there will be one plastic connector. If there are more than one, use masking tape and a marker to label them for reassembly.

     

    Step 4:Using a socket, unscrew the screws that secure the blower motor to the heater case or firewall. Pull the blower motor and fan blades from the vehicle as an assembly.

     

    Step 5:Replace new Blower Motor, Installing the Blower Motor.

     

    Step 6:Slide the motor/fan blade assembly into position in the heater case or firewall. Screw in the screws that secure the blower motor to the heater case or firewall.

     

    Step 7:Press the plastic wiring connector onto the back of the blower motor.

     

    Step 8:Reconnect the ground cable to the negative battery terminal. Slide the clamp over the terminal and tighten the retaining bolt with a wrench.

     

    FAQ Anwser

    1.About shipping: We have two warehouses in US, one is located in CA, and other one is located in GA. We will dispatch packages from the nearest in stock warehouse by recipient's address accordingly. Up to 99% Orders could be shipped within 24 hours after payment completed. 

    2.About incompatibility parts received: Please provide us with detailed vehicle information including Year/ Made/Model/Trim and Engine, or VIN#. With these information, we could try to help to find out a correct OE# part or exchange a right one for you if we have it in stock.

    3.About damaged package: Please take some photos of the damage part and send to us, we will inspect it carefully and confirm with engineer if the damage will cause functional or installation issues or not. For serious damage radiator, we could do resend a new one or issue refund as compensation. 

    4.About shipping method: UPS, FedEx, USPS are available here and we will choose one of them according to the part you order, for generally speaking, the delivery time is about 3 to 8 working days.

    5.Why choose us: Professional auto parts seller, Premium Quality Products, Excellent service, Satisfactory shopping experience.

     

    6.Other questions: Please message us before order.

     



    Paypal are the accepted forms of payment.

    Please use the eBay checkout system when paying for your order. 

    We have two warehouses in US, one is located in CA, and other one is located in GA. We will dispatch packages from the nearest in stock warehouse by recipient's address accordingly. Up to 99% Orders could be shipped within 24 hours after payment completed. 

    ​UPS, FedEx, USPS are available here and we will choose one of them according to the part you order, for generally speaking, the delivery time is about 3 to 8 working days.

    Shipping services only cover 48 states and Washington DC in US Continental, while most of the time Alaska, Hawaii, Puerto Rico, American Samoa, U.S. Virgin Islands, Northern Marianas, Guam are not deliverable. USPS PO Box, APO Army Post Office, FPO Fleet Post Office addresses are not available

    Your auto parts sometimes might be shipped with two or more separated packages due to weight limitation, please keep patient with no Item Not Received claim or Return request filed until by all of your items are received.

    3 YEARS WARRANTY

    All of our brand new items come with a 60-Days money-back guarantee.

    We will replace the defective items, provided that they are in stock within the warranty period posted with the listing and the buyer return the original item and pay for the S&H cost for the replacement

    We will refund the purchase price if the replacement is not available or buyer prefers a refund and send the original item back at his/her own cost. 

    Man-made damage by abuse or wrong operation is not covered by this warranty.

    Refunds will be credited within 1 to 5 business days of receiving the return. 

    1. Any Questions Please Message Us Before Order

    All rights reserved.