WASTE OIL HEATER BURNER WARM AIR HEATING

MTM 52 kW       Air flow 5500 cubic m / hr 
 TURBINE FAN AND HEAT EXCHANGER INSIDE 


Heater  universal oil MTM 30-52 is designed for heating industrial spaces outside the central heating system,
 such as basements,
garages,
 workshops,
 warehouses, 
industrial buildings,
 farm buildings etc. 

Type of fuel that can be used in the heater: 
- Vegetable oils (BIOFUELS) 
- Waste vegetable oils  (from restaurants and catering) 
- Mineral and synthetic oils 
(used oil engine, transmission, hydraulic, power of HBO I, II, III, with a viscosity of not more than SAE80) 

Heat output: (with  good insulation) 
MTM heater efficiently heats a space of upto 1500 cubic meters. 
 
Characteristic of the heater :
 
- Variable power from 30kW to 52KW NEW!
102364 to 177431  BTU (th)/hour [Btu(th)/h]
- Protection against overheating 
- Overflow protection of oil in the furnace 
- Built-in microprocessor controller 
- Traffic lights with LEDs furnace defects 
- Aesthetic cover with powder coating 
- Combustion chamber (3 years warranty*) made of stainless steel 
  High temperature resistance

- Manual ignition 
- Warm air outlet temperature 70°C to 90°C 
   (From the outside air temperature about 12°C) 
- Radiant heat in all directions - 
TURBINE FAN AND HEAT EXCHANGER INSIDE
- Air flow 5500 cubic m / hr 
- Oil consumption 3.0 l / h to 5.2 l / h 
- Tank capacity 90 l 
- Weight 130 kg 
Length 120 cm: Width 60 cm : Height 130 cm



* 1  year warranty on the rest of the heater components


THE FLUE KIT NOT INCLUDED .WE SELL IT SEPARATELY.

the heater works properly only with the appropriate chimney flue (4-5 meters minimum with a dedicated cross-section of 150 mm)
Attempts to test run it without a chimney usually end with switching on the overflow system.
So please install the flue kit correctly and only then complain about a defect, not the other way around, because these are usually the rules of physics, heater not work without flue kit and correct draft .