Hand crank generator Three-phase permanent magnet brushless outer rotor
Instructions for use:
1) This series of generators is mainly suitable for charging small batteries, so when using this motor, AC power needs to be converted into DC power (this product has a set with rectifier, LED light chip and hand crank, please contact customer service if necessary) . It needs to be rectified and filtered. The schematic circuit diagram (above): In the figure, G: generator, its three output wires can be connected to D at will regardless of the phase sequence; D: diode, optional IN4001 (recommended) ; C: Electrolytic capacitor with a capacity of 470uF-2000
uF/16v selection;
2) The number of teeth of the motor main shaft gear is L=10, the gear modulus m=0.5, and the pressure angle a=20°.
3) When the noise of the motor increases, gear lubricating oil can be added to the motor gear.
1) This series of generators is mainly suitable for charging small batteries, so when using this motor, AC power needs to be converted into DC power (this product has a set with rectifier, LED light chip and hand crank, please contact customer service if necessary) . It needs to be rectified and filtered. The schematic circuit diagram (above): In the figure, G: generator, its three output wires can be connected to D at will regardless of the phase sequence; D: diode, optional IN4001 (recommended) ; C: Electrolytic capacitor with a capacity of 470uF-2000
uF/16v selection;
2) The number of teeth of the motor main shaft gear is L=10, the gear modulus m=0.5, and the pressure angle a=20°.
3) When the noise of the motor increases, gear lubricating oil can be added to the motor gear.
Packing：1PC
Warranty period: 120 days
