320A brushed ESC Built-in capacitor Can be equipped with 540/550 brushed motors! ! Very good value!

The new ESC has integrated the capacitor into the ESC, the integration is more practical. Automatically learn the middle position!! Perfect match with Ni-MH battery!!

 

1. Automatically find the center position! !
2. High frequency drive system!!
3. Overheating protection function!!
4. Low voltage protection function !!
5. Use low internal resistance field effect inner tube!!
6. With forward and backward functions, suitable for cars and boats!!

Forward current: 320A!!
Backward current: 240A!!
Voltage range: 4.8-8.4V (LI-PO7.4V or 1.2V for 6 sections)
PWM frequency: 1.5KHZ
BEC output voltage: 5.0V.

Operation guide:

1. Connect to the power supply battery correctly. The red wire at both ends of the wiring board is the positive pole, and the black is the negative pole. (Or connect a standard DC battery plug)
2. Turn on the power switch, if there is no signal input at this time, the motor will emit a "beep~beep~beep" alarm sound. The alarm sound will stop when a normal signal is injected.
3. Turn on the remote control, adjust the fine-tuning to the neutral position, and the red and green indicator lights will go out. The green light of the hand push forward is on and it is forward. Then pull the hand push back over the center and enter the brake state. The larger the pull back, the tighter the brake. Put the palm back to the middle position and pull it back again and enter the reverse state. The red light is on. It is equipped with about 550 motors!

Note: It is forbidden to enter water and reverse the polarity of the power supply!
The external current of the brushed ESC below 320A is 1A!