Product Details
1. The output voltage is 110~2600V DC, you can turn the voltage adjusting button clockwise to make the voltage bigger, and counterclockwise to make the voltage smaller.
2. The output current is 0.25~3.4mAh, you can turn the voltage adjusting button clockwise to make the current bigger, and turn counterclockwise to make the current smaller.
3. When testing MOS tubes, transistors and Zener diodes, it is recommended to adjust the current to the minimum size of 0.25mA. When testing LED backlight boards, it is recommended to adjust the current to a maximum size of 3.4mAh.
4.Portable size: the small size of this tool is very convenient for daily use, you can carry it in your tool bag without taking up too much storage space.
5.Built-in 600 mAh high-capacity lithium battery power supply, which can be charged in time through the Type-C port.
6.Wide range of applications: the tool can be widely used for MOS, triode, IGBT, diode, Zener diode, diode bridge maximum voltage capacity test, capacitor and varistor voltage verification, LED backlighting and light board test, etc.
Battery capacity: 3.7V 600mAH
Charging port: TYPE-C
Input: 5V 1A
Charging current: Max.550mA
Output voltage: 120-2700V
Output Current: 0.2-3.8mA
Applicable components: MOS tube/IGBT/transistor/diode/electrolytic capacitor/LED/MOV/one-way thyristor/rectifier bridge
Test Objective: Breakdown voltage value of electronic components
1. Don't use it to test high voltage large electrolytic capacitors such as 450V/220UF. It is OK to test low voltage capacitors such as 2200UF/35V.
2. If there is no output voltage when pressing the red high-voltage start button, it is likely that the voltage of the lithium battery is lower than 3.1V, which can't energise the tester, and it needs to be charged in time.
3. Only when testing LEDs and voltage regulator diodes, the output current can be adjusted to the maximum value, for testing other parts, the output current can be adjusted to the minimum value to avoid damaging the parts.
Standard version: host * 1 + manual * 1 + meter pen * 1
Advanced version: host *1 + manual *1 + pen *1 + LCR test clip *1
- Payment must be received in 5 business days of auction closing.
- Please leave note for your special request (e.g. Colors or Size) when you pay the order.
- Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
1. We only ship to the confirmed address provided by eBay. please make sure your ebay address is 100% matches the address you would like us to ship to. If not, please let us know before we sent you the package, or we will not be responsible for any loss. hope you could understand.
2. Orders will be processed instantly and dispatched within 1-3 business days except hoilday, so we do NOT accept any email/message note after you place orders.
3. All package need to wait 30 days,Please take care it.Less than 30 days,we can't take a refund.
We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important to us. We request that you keep in touch with us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.