This is a custom designed, full-body, play-through case/shell for the Analogue Pocket handheld game system. It's a two-piece, 3D-printed shell made from an eco-friendly, bioplastic material known as PLA. The case has four individual felt lined channels on the interior sides and top, cushioning Pocket while in use. The felt is made from long-lasting, fine touch polyester. The Analogue Pocket slides down into the bottom case, then the top is secured with a set of included two M2.5 16mm bolts and nuts; mini allen wrench also included.
A generous cutout is present at the bottom of the case to allow for all ports to connect, as well as the sides for power, volume, and micro SD card access. Additionally, sixteen speaker hole cutouts are present, eight on each side, designed to allow audio to pass through without interference.
A lot of work went into modeling and prototyping this case. I carefully manufacture and test each one using my own Analogue Pocket. It takes several hours to produce just one case and I make sure that each one passes my level of quality assurance.