Introducing our DC 12V 1CH Relay Receiver RF Transmitter Switch – the ultimate solution for seamless remote control! Elevate your experience with cutting-edge specifications that guarantee top-notch performance and reliability.

    Input Voltage: 12 V

    RF Working Mode: Superheterodyne

    Receiver Sensitivity: > 97 dB

    Transmitting Distance: > 100 m (open space)

    Decoding Mode: MCU Software Decoding

    Remote Storage: 20

    Support Remote Type: EV1527 Learning Code

    Working Modes: Momentary, Toggle, Latching Time Delay (5s, 10s, 15s)

    Output Terminal: NO, NC, COM

    Dimension of PCB: 35 x 30 x 18 mm (L, W, H)

    Remote Control Battery: 2 x 3 V CR2016 Button Batteries

    Maximum Input Power: 250 V

Remote Programming Control (Not Included):

    Clearing the Code:

        Push the learning button on the receiver 8 times to reset the codes.

        After clearing the code, remotes will need to be recalibrated.

    Momentary Mode:

        Contact us for detailed use instructions.

    Learning the Code (Toggle - Press remote button to turn on, press again to turn off):

        Press the learning key on the receiver 2 times; the LED will go off, indicating the learning state.

        Press the learning key on the receiver 3 times; the LED will blink 3 times.

        While the LED is on, press the remote button (A or B) you want to let it learn.

        After 3 seconds, the LED indicator will turn off, indicating successful learning.

Introducing our latest IC 2262/2272 4 CH Key Wireless Remote Control Kit, featuring cutting-edge technology for seamless control and unparalleled convenience.

    Brand New: 100% Brand New

    Operating Voltage: DC12V (27A/12V battery x1)

    Size: 6.2 x 3.8 x 1.4cm (LxWxD)

    Modulation Mode: ASK (Amplitude Modulation)

    Transmitting Frequency: 315MHz (SAW frequency stabilization)

    Transmission Distance: 50-100M (Open field; receiver sensitivity -100dBm)

    Encoder Types: Fixed Code

    Frequency: 315MHz

    Decoding Receiver Board: Operating Voltage DC5V, Receiver Sensitivity -98dB

        Leg Configuration: 7 bits - VT, D3, D2, D1, D0, +5 V, GND

        VT is a valid signal high output pin; upon receiving a valid signal, the pin output goes high and can drive the relay.

    Size (Receiver Board): 62241mm

    Four buttons on the remote control correspond to the four data bits on the receiving board's output pins (D0, D1, D2, D3).

    Pressing the buttons transmits signals, and the corresponding data bit is output high.

Note: Our item comes WITHOUT a battery; battery not included.