Features:
100% brand new with high quality metal case (not plastic)
Works for oil,fuel,diesel,gas,water,air pressure.
Can be used with oil, water, fuel, air, etc.
Easy to install with included connector (wiring instructions below)
Specifications:
100 psi
Input 0-100 psi
Output: 0.5V – 4.5V linear voltage output. 0 psi outputs 0.5V, 75 psi outputs 2.5V, 150 psi outputs 4.5V.
Accuracy: within 2% of reading (full scale).
Thread: 1/8”-27 NPT.
Wiring connector: water sealed quick disconnect. Mating connector and wire harness (pigtail) is included.
Wiring: Red for +5V. Black for ground. Green for signal output.
Overload Capacity: 2-4 times;
Working Temperature: -40—+120ºC;
Compensation Temperature: -20—+80ºC;
Protection Class: IP67;
Pressure Medium: The gas and liquid which is compatible with 316L stainless steel;
Load Resistance: ≤ (supply power-6.5V/0.02A)Ω;
Long-term stability: Less than 0.1%FS/year;
Temperature Effect on Zero: Typical:0.02%FS/ºC; Maximum:0.05%FS/ºC;
Temperature Effect on Sensitivity: Typical:0.02%FS/ºC; Maximum:0.05%FS/ºC;
Shock Resistance: 1000g;
Anti-Shock: ≤+/-0.01%FS(X,Y,Z axes, 200Hz/g);
Response Time: ≤1ms;
Insulation Resistance: >100mΩ 500VDC;
Explosion-proof Class: ExiaTTCT6;
Electromagnetism Compatibility: EN50051-1.
Wire Harness Length:33mm(We are the original factory of the sensor, if the wiring harness or other need to customize please send us an email )
Note: Remote mounting of these sensors is recommended as direct engine vibration
will cause prem be mounted on oil filter relocators, fuel pressure regulators, etc.
when isolated from the engine by hoses. ature failure and void the warranty.
This means the sensor cannot be mounted to anything that is directly attached to the engine
(fuel rails, oil block adapters, etc). They can be mounted on oil filter relocators
fuel pressure regulators, etc. when isolated from the engine by hoses.