KC22B02 DC 5V 2 Channel Multifunction Delay Relay Module Cycle Timer Relay Switch Module 0-9999s for Motor LED Smart Home
Function mode:
After F1 is powered on, relay 1 is switched on and relay 2 is disconnected; after T1 time delay, relay 1 is switched on and relay 2 is switched on; after T2 time delay, relay 1 is switched on and relay 2 is switched off, and the cycle is repeated (positive and negative motor rotation).
After F2 is powered on, relays 1 and 2 are drawn, after T1 time, relays 1 and 2 are disconnected, and after T2 time, relays 1 and 2 are drawn, and so on.
After F3 is powered on, relay 1 is switched on, relay 1 is disconnected after T1 time, relay 1 is switched on after T2 time, and so on. Relay 2 is not working.
Relay 2 is disconnected after F4 is powered on, relay 2 is drawn after T1 time, relay 2 is disconnected after T2 time, and so on. Relay 1 is not working.
F5 After powering on relay 1 and 2, disconnect relay 1 and 2 after T1 time (control neutral line live line).
F6 After power-on, relay 1 is plugged in. After T1, relay 1 is disconnected and relay 2 does not work.
After F7 is powered on, relay 2 does not work. After T1 time, relay 2 draws and relay 1 does not work.
After F8 is powered on, relay 1 and 2 are simultaneously switched on, and relay 1 is disconnected after T1 time and relay 2 is disconnected after T2 time.
F9 After power-on, relay 1 2 does not operate. Relay 1 closes at T1 time and relay 2 closes at T2 time.
Function mode selection:
Press and hold K1, trigger K2, switch function mode
F5 F6 F7 mode has only one counter (T1), other modes have two counters (T1 T2); Press and hold K1, trigger K3, switch T1 T2 time adjustment.
Adjusting delay:
Press K2 to switch the 100 thousand bits of the time, the selected bit will blink, and then trigger K3 to adjust the delay.
Adjust the hundred thousand in the same way.
After switching all bits, press K2 to exit the adjustment delay mode; Or press K1 to exit the delay adjustment module; Or automatically exit the adjustment delay mode after 10 seconds without performing any operation.
Display mode:
Press K3 for 5 seconds to stop the display, then press K3 for 5 seconds or power it on again to display normally.
F5 F6 F7 F8 F9 mode, after countdown, trigger relay, stop counting and stop display, enter low power mode, press K1 to exit low power mode.
Note:
1. Due to the light and screen difference, the item's color may be slightly different from the pictures.
2. Please allow 1mm-1cm differences due to manual measurement.
Package Included:
1x Relay Module