DC 9V-36V THB6128 2 Phase 4 Wire Stepper Motor Driver 128 Subdivision Current 2A 57 Stepper Motor Control Driver Board with Power Indicator
Feature:
Chip using double full-bridge MOSFET driver, low on-resistance Ron = 0.55Ω.
Reasonable alignment, clear identification, reliable and stable, with power indicator.
Maximum voltage 36V, peak current 2.2A, continuous current 2A, the current set by DIP switch simple set.
8-step subdivision (1/2/4/8/16/32/64/128) a variety of sub-optional, subdivided through the DIP switch to set.
Built-in 5V logic signal supply regulator chip, and add a current limiting resistor to reduce the chip fever when the input high voltage.
Chip with automatic half-flow lock function, greatly reduce the heat when the motor is locked. Chip built-in temperature protection, over-current protection, input voltage side reverse polarity protection.
Specifications :
Input voltage: DC 9V~36V
Input current: 0.01A~2.2A
Output current: 0A~2.2A
Working temperature: -20℃~60℃
Storage temperature: -40℃~80 ℃
Operating humidity: no condensation, no water droplets
Gas environment: Prohibition of combustible gases and conductive dust
The module is based on the original imported Toshiba stepper motor drive chip THB6128 design, can drive 57 and the following two-phase four-wire stepper motor
Note:
1. Due to the light and screen difference, the item's color may be slightly different from the pictures.
2. Please allow 1-3cm differences due to manual measurement.
Package Included:
1x Stepper Motor Driver
