Specification:

• Brand  new and high quality

• Length: Approx.5cm

• Hole size: Approx. 6mm

• Need Cooling and lubrication

• Diamond hole saw tile ceramic glass porcelain marble drill.

• Always use lubrication (water) , if not the diamond core will over heat.

• Use for conventional power drills on the low speed setting with the hammer action disabled.

• These are auiable for drilling ceramic tiles, glass, marble, slate and porcelain tiles up to hardness grade 5

• If you're drilling on a vertical surface try a hand spray water bottle, or sponge soaked in water and held underneath, but in contact with the drill bit.

• Keep the bit as wet as possible during operation, if the bit dries out during use it will overheat and immediately blunt

• Clamped firmly to a bench to allow for slow controlled drilling.

• If drilling in situ or at an awkward angle, cna try following method:

• Make a template from a piece of timber or waste material, locate this over the area where you want to drill your hole and use it as a "guide" to start the hole.

• Once you've got into the surface by 1mm to 2mm you can remove the guide and continue to drill in a controlled manner.

• Start your hole diagonally, make a round trace and then hold drill straight

Package included:

• 10 x Diamond Holesaw 6mm Drill Bits Tool