Offered is the XL model of the “Landscape Staple Multi-Driver©️”, (patent pending).

It's a must have tool for landscapers, garden nurseries and even home owners. It makes the task of inserting landscape stables over fabric, in sod, and over above ground irrigation lines much easier.
Instructional videos can be viewed on this ad or on Youtube by searching on "Landscape Staple Multi-Driver". If you haven't seen the Instructional Videos here are some important steps you should know about in using the Multi-Driver.
1) insert the staple into the bottom as far as it will go (it will be held in place by a magnet).
2) while holding the Outer Housing, place the staple on the ground where you want to insert it.
3) push down on the Outer Housing making the bottom flush with the ground.
4) while holding it down push down on the Driver Shaft Handle to insert the staple as far as it will go.
5) while continuing to hold the Outer Housing flush with the ground lift the Driver Shaft upward 3 to 4 inches and turn the shaft ¼ turn in either direction (make sure you have the Driver Shaft lifted before turning it).
6) push down on the Driver Shaft to complete the insertion (lift the Driver Shaft up and down to drive the staple in if necessary).
Instructions are included with the product and once you do it you will see that it is much simpler than it sounds and works great.
One of the primary benefits of the XL model is that it is approximately 44" tall and can be used from the standing position.

Free Shipping to all lower 48 states.

Designed and Made in the USA.