The original steering links on this Truck are ultra weak, poorly designed, and flex with nearly ANY pressure... This is clearly the biggest Design Flaw on what is otherwise a great Truck! Lets fix that problem in less than 5 minutes with these Upgraded steering links!!!
You get set of 2 (two) steering links 3D-printed out of Super Ultra durable black ABS+ (plus)
----> ABS+ Plus is even STRONGER than regular ABS!
Each order comes with a set of 2 links, one for each axle!
Installation Instructions:
1. Leave the truck OFF; pop the servo link from the ball joint, then remove original ball joint from original steering link (5mm socket)
2. Re-install ball joint into the Upgraded Steering Link. Do NOT over Tighten, just snug it.
------- Do Not Over Tighten! ---------
3. Remove the original steering link; leave the original screws in place in the steering knuckles
5. Screw the new steering links into place using the original screws. Again, Do Not over tighten, you want a tiny bit of play here...
6. Pop the servo link back onto the ball joint.
7. Repeat for the other end of your Rig, then enjoy Proper Steering!!!
I stand by my designs! Should you actually manage to break these things, please message me and include pictures of the broken part(s). I will replace them at no charge!
----> Check out my other Danchee Crawler upgrades listed below!
Steering Links
https://www.ebay.com/itm/295446906355
Axle Links
https://www.ebay.com/itm/295077507411
Body Panels
https://www.ebay.com/itm/295417443509
Low Profile Servo Tray
https://www.ebay.com/itm/295568127743
High Profile Servo Tray
https://www.ebay.com/itm/295568158134