Feature:

Support multi-layer overlay to increase power and capacitance.

Support subsequent expansion modules, support single-sided or double-sided battery.

High current wiring, Full-chip high-current protection board and battery holder.

High Conversion efficiency, Support multi-layer balanced release.

With over-voltage protection function to prevent overshoot or over-discharge.

With voltage equalization function, to ensure that multiple sets of voltage are the same, increase the life of the battery pack.

The protection plate can provide a balance equalization function for the entire multi-layer battery case, without having to add a protection plate to each layer.

Easy and simple to use and operate, no other tools needed to install.

Installation: Install the battery according to the positive and negative sides on the circuit board. Be careful not to reverse it.

Specifications:

Item Type: Battery Holder Protection Board

Material: plastic+metal+electronic components

6S1P without BMS ：Weight :  96g、Size :151*85*23mm 、Voltage :  24V    

6S 1P 40A BMS： Weight :  121g 、Size:151*85*24mm、Voltage :  24V  、Electricity :40A

6S 2P：Weight :  145g  、Size :150*85*45mm  、Voltage :  24V

Warm Tips:

25.2v charger is needed for 6S charging.

It is recommended that the charging current of each layer should not exceed 2A, otherwise the battery may become hot (for example, choose 2A charger for only one layer, and 4A charger for two layers).

Do not put on the metal table top to use, pay attention to insulation do not short circuit.

The battery faces up the circuit board, all the batteries face the same cannot interleave.

Do not connect the wrong power supply, the circuit board is marked, pay attention to the observation.

Package Includes:

1 Set x Battery Holder Protection Board Kits