Sea-Doo 2006-2008 GTI / GTI SE/ GTI 130 Rental/ GTI 130 Seat Cover

Sea-Doo 2009-2010 Wake 155

Introducing a new look with a fresh Blacktip Jetsports Standard Seat Cover!

COLOR: YELLOW / LIGHT GRAY / BLACK VINYL  

Our Blacktip Jetsports Standard Seat Cover allows you to select from a variety of standard seat cover color options at a great price, saving you time and money, as these seat covers are in stock and ready to ship! The cover is made from high quality marine vinyl and designed to last for years. The individual section provides for a tight, custom fit and look.

RETURNS ARE NOT ACCEPTED

BlackTip Jetsports Seat Cover Color Samples may view differently than actual color, depending on monitor settings.

APPLICATIONS:

2006 GTI RENTAL
2006 GTI SE
2006 GTI STD

2007 GTI 130
2007 GTI RENTAL 130
2007 GTI SE 130
2007 GTI SE 155

2008 GTI 130
2008 GTI RENTAL 130
2008 GTI SE 130
2008 GTI SE 155

INSTALLATION: Installation of your new seat cover is easy and can be done by most do it yourselfers. Listed below are the tools and supplies you will need:

- Staple Gun (preferably electric or air powered)
- Stainless Steel staples to fit your gun
- Needle nose pliers
- Flat blade screwdriver or other type of tool to pry out staples
- Scissors
- Utility knife
Some seats have straps, handles, or brackets they may require additional tools for removal.

Most BlackTip Jetsports seat covers are designed to install over your factory cover. The old cover may need to be removed or sections of it removed if it is torn or damaged. If the original is badly damaged or the seat foam is wet you should remove it completely and let the foam dry before installing the new cover.

If the foam is damaged you will need to repair it before installing the new cover or the damage will show through. Small cracks can usually be repaired with duct tape to hide the damage. Larger repairs can be made by replacing the damaged foam and then sanding the new foam to match the shape of the old foam. If your seat has extensive damage we recommend taking it and your new cover to a local upholstery shop.

Installation of the cover is easiest if the vinyl is warm, a nice sunny day, a warm shop, or a hair dryer can accomplish this. Make sure you do not have any sharp corner or protrusions before installing.

Align the cover onto the seat so that it is centered over the main section of the seat. Put a staple at each corner or curve including the front of the seat (these staples may need to be removed later as you stretch the material into place). Once you have the material aligned you can continue stretching and fitting the cover around the seat. As you staple and stretch it may be necessary to trim away excess material. You will want to use many staples around the perimeter of the seat use the original as your guide. After the cover is completely stapled in place you should trim away any excess material.

On some models with a strap you can reinstall the strap at this time if you prefer.

CLEANING: Cleaning and Maintenance of the seat cover should be done periodically to help extend the life of the cover. To clean the cover, we suggest a mild liquid soap similar to soap used to wash the PWC. For bird droppings or other hard to clean spots, it may be necessary to use a scrub brush. You can rinse the cover with a standard garden hose. We do not suggest using a pressure washer since the pressure could be high enough to damage the material.

Code: 108BT107-P