Shop categories
Item Details
Window tint Film Installation Instructions
You will need:
- Roll of Chameleon tint
- Scissors/cutting knife
- Heat Gun
- Spray bottle containing water with a few drops of Tint Slime
- squeegee or credit card wrapped in kitchen towel
Method:
1) Thoroughly clean the vehicle where the film will be applied to.
2) Cut your film to size of the window, adding an extra 2cm to the width and height.
3) Lay film on glass from the out side with films backing facing outwards and heat shrink if required(see fitting videos for reference)
3) Remove the clear lining film from back of the window film and spray the adhesive back of the film, as well as your fingers, with the soapy water solution. (Tip: If you cannot remove the clear lining film, attach a piece of sticky tape to either side of the film at one corner and peel away from each other).
4) Spray the window with the soapy water.
5) Apply the adhesive side of the film onto the glass and slide into position.
6) Spray the face of the film with the soapy water and using a squeegee or credit card wrapped in paper towel, squeegee out all the soapy water from behind the film
7) Trim off any excess film using a sharp knife for a neat finish
About Us
Based near Chester and established over 10 years ago, we are one of the UK's leading suppliers of window tints to professional and DIY users.
All of our window tint is carefully sourced to make sure you are getting the best product that is easy to install and is of a high quality.
We can offer expert advice on fitting or using any of our products.