1. Power tube: imported power tube;
2. PCB: Double-sided 2 oz;
3. Stable performance;
4. Large radiator, fast heat dissipation
5. Frequency 40Khz
Instructions for wiring the circuit board and the vibration head:
1. The circuit board cannot be powered on under no-load conditions;
2. When installed and cleaned, it cannot be powered on without any cleaning solution;
3. There are two lugs on the vibrating head. The lug in the middle of the two ceramic plates is the positive pole, and the one near the upper and lower metal posts is the negative pole. Remember not to connect them in reverse;
4. The larger side of the vibrating head (with a screw hole) is the vibrating surface, which can be stuck to the bottom of the cleaning basin, and the cleaning basin must be reliably grounded;
5. The vibrating head or transducer ceramic sheet should be firmly attached to the bottom of the cleaning basin with vibrating head glue, or AB glue.
6. OUT+ is connected to the positive electrode of the transducer (vibrator), OUT- is connected to the negative electrode of the transducer (vibrator), and the positive and negative electrodes of OUT are connected to the positive and negative electrodes of the transducer (vibrator) respectively.
,Remember not to make mistakes.
(Note: The voltage on the circuit board is 600V, and the voltage on the output terminal is 1100V. Pay attention to safety. There is a leakage protection switch on the input power supply to ensure safety!) If you have any questions, please consult in time to ensure safety.
7. When the circuit board is working, the voltage on the board is 600V, and the voltage output to the transducer is 1100V. Remember to ground the cleaning basin reliably, and have a leakage protection switch on the power supply to ensure safety.
Packing:1PC
Warranty period: 120 days